- The problem
- Mack is recalling certain model year 2008 through 2011 gu and mru model vehicles manufactured with a front tow glad hand option. The actuation and release timing of the vehicles exceeds the limit which fails to conform to the requirements of federal motor vehicle safety standard no. 121, "Air brake systems."
- The risk
- If the brakes do not perform as they should, a vehicle crash could occur.
- The fix
- Mack will notify owners and repair the vehicle free of charge. The safety recall began on february 1, 2011. Owners may contact mack at 1-877-800-4945.
Brakes
2008 Mack GU Brake problems
No owner has filed a complaint about the 2008 Mack GU's brakes with NHTSA. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
- Complaints
- 0
- Recalls
- 4
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Brake recalls for the 2008 Mack GU
- The problem
- On certain trucks equipped with parker single check valves (scv) provided by bendix. The defect exists in the parker scv that connects with the supply port of the sr-7 spring brake modulating valve. After prolonged use of the parker scv, the valve body retainer may become excessively worn and eventually break apart. Pieces of the parker scv can become lodged inside the sr-7 spring brake modulating valve, potentially causing either leakage out of the sr-7 valve or preventing air from properly exhausting from the sr-7 valve.
- The risk
- This condition can cause a delay in the application of the spring brakes to park the vehicle after the operator pulls the dash valve button. These conditions can occur without warning, leading to unintended vehicle rollaway, brake drag, or in the case of loss of primary circuit, inability to modulate the spring brakes.
- The fix
- Mack is working with bendix to replace the parker single check valve. The recall began on january 9, 2008. Owners may contact bendix at 1-440-329-9000 or mack at 1-800-528-6586.
- The problem
- On certain trucks equipped with bendix sr-7 spring brake modulating valves, the internal rubber check valve may leak causing a delay in the application of the spring brakes to park the vehicle after the operator pulls the dash valve button.
- The risk
- This could delay or failure in applying the parking brakes which could result in a vehicle roll away, increasing the risk of a crash.
- The fix
- Mack is working with bendix to repair these vehicles (please see 07e037). Bendix will install a check valve repair kit for the affected sr-7 spring brake modulating valve free of charge. The recall began on january 10, 2008. Owners may contact bendix at 1-440-329-9000 or mack at 1-800-528-6586.
- The problem
- On certain trucks, the cotter pin that retains the brake pedal clevis pin may not have been installed. The clevis pin connects the brake pedal to the brake foot valve.
- The risk
- If the pin were to come loose, the driver would not be able to apply the service brake, which could result in a crash.
- The fix
- Dealers will inspect to see if the cotter pin is missing. If the pin is missing, the cotter pin will be installed. Owners are being advised not the drive the vehicle until the pin has been installed. The recall began on march 26, 2007. Owner may contact mack truck at 1-800-528-6586.
Brake complaints
No complaints about this area yet.
Mack GU brake complaints by year
GU brake problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data