2011 Mazda 3 rear tire wear issues: car has uneven tire wear, (inside edges) even when tires get rotated, car is also aligned correctly, no front end issues. After normal driving, the tires get a bad feathering wear issue, creating uneven (inside edge) wear and premature tire usage. This should be reviewed and recalled or class action lawsuit should occur. It's a manufacture defect in engineering, and very common, costing owners thousand of dollars over ownership life. *Tr
Wheels & tires
Mazda MAZDASPEED3 Tire problems by year
8 complaints filed with NHTSA about the Mazda MAZDASPEED3's wheels & tires. Tire failures, tread separation, wheel bearings, lug nuts, rims and tire pressure monitoring.
Tire complaints by model year
Latest MAZDASPEED3 tire complaints
This has happened more than just the date listed here. The tire pressure sensors (tps) on this and other vehicles are prone to corrosion and failure. This is because the exterior stem is aluminum and the interior core is another metal (nickel-plated, perhaps) and the entire sensor body is energized. When the tps is exposed to road salt and snowmelt, the aluminum corrodes and can break off, causing an uncontrolled deflation of the tire. This happened to me and my wife on two occasions while changing a tire and I have heard of other instances in which drivers have experienced catastrophic failure of the tps and tire deflation at highway speeds. *Tr
I was using a michelin green x tire for about 2 years an mileage of 50000. In a 45 degree curve suddenly my tail went out of control and I ran into the middle separate of road,caused a lot of wreckage . I was told that this was because of low rear tire grip to the road. *Tr
Tl* the contact owns a 2008 mazda speed 3. The contact stated that while driving 65 mph, the tpms sensor light illuminated and the front driver side tire blew out. The contact was able to pull to the side of the road. The contact towed the vehicle to the dealer. The dealer stated that the tpms sensor had fractured and caused the blow out. The dealer also stated the remaining tpms sensors were also fractured. The contact called the manufacturer and filed a complaint. The failure mileage was 42,000.
When driving at highway speed for an extended period of time, the excessive wheel camber made the tire heat up and wear through on the inside edge, and blow out. This happened again the next day. *Js
I installed the aftermarket mazdaspeed lowering springs on my mazdaspeed3, carefully following the supplied instructions. The instructions require removing the bump stops from the strut mounts. I thought this was strange, but I did it, and later found that my right-front tire tread surface had made contact with the top of the inside of the fender. The result was deep circumferential grooves in the tire, and the plastic fender liner was completely worn away in one area. This is potentially very dangerous since it could lead to a tire blowout. And yes, I am certain that the instructions show the removal of the bump stops. I have the instructions and photos of the damage. *Tr
Tl*the contact owns a 2007 mazda speed 3. While driving less than 10 mph, the vehicle went into a full skid and struck a curb. Five miles later, the vehicle lost steering ability and the wheel turned completely around. The vehicle was taken to a dealer and they replaced the failed steering rack. The contact stated that the dealer was selling vehicles with summer tires. There were no injuries. The current mileage was 8,800 and failure mileage was 8,780. Updated 01-30-08. *Kb the consumer stated failure warn about to summer rated tires. Updated 01/18/08 *tr
I have a bridgestone potenza tire with 5k miles on it and it has a bulge in the sidewall.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data