On certain trucks equipped with 3rd generation conmet aluminum wheels, the drum mounting flange on the conmet truturn brake drum may have been manufactured with a taper from the pilot hole to the barrel of the drum.
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
Certain freightliner trucks and thomas school buses equipped with holland/neway air suspension systems, a transverse beam casting may fracture under normal loads. If a casting breaks when the vehicle is traveling on a roadway there is the potential for...
On certain commercial buses equipped with vapor door assemblies, the two piece curved connecting rods when used as an element of the door actuation linkage in conjunction with a vapor medium pneumatic differential engine, may be subject to fatigue failure...
Certain class c motor homes built on chevrolet chassis fail to comply with the requirements of part 567, "certification." The federal certification tag was printed with the incorrect rear gross axle weight rating (gawr) and incorrect cargo carrying capacity...
Certain motor homes fail to comply with the requirements of federal motor vehicle safety standard no. 120, 'Tire selection and rims for motor vehicles other than passenger cars.' The front and rear tire cold tire inflation pressures of 125 psi exceed the...
On certain motorcycles, the lower by-pass coolant hose can rupture.
Certain motor homes built on ford e-450 chassis fail to comply with the requirements of federal motor vehicle safety standard no. 120, 'Tire selection and rims for motor vehicles other than passenger cars.' The tire pressure is incorrectly listed on the...
Certain pickup trucks, sport utility vehicles and vans equipped with 6.0L diesel engines may experience stalling without warning while driving and may or may not restart.
On certain pickup trucks and chassis cab vehicles equipped with 5.4L or 6.8L gasoline engines, the fuel jumper line may have an incorrect end form.
On certain motor homes, the harness and cables were routed incorrectly. Sharp casting edges of the transmission lifting ear cut into the cables or the wire harness.
On certain passenger vehicles, a vapor hose located in the fuel tank may not have been formed correctly during the manufacturing process. When the vehicle is parked with a full fuel tank, fuel may flow into the vapor hose, which is connected to a vapor...
On certain motor homes equipped with optional rear suspension air bags, the upper mount can move and contact the tire.
On certain class a motor homes equipped with vehicle systems' aqua-hot and hydro-hot water heaters, which use webasto burner tubes, the burner tubes do not meet specifications and could fail prematurely.
On certain motor homes equipped with ametek ngi gauges, the air gauges are not properly calibrated and the low air warning indicator may be activated when actual air reservoir pressure readings are below the federal motor vehicle safety standard required...
On certain light duty trucks, the battery cable may have been routed incorrectly during vehicle manufacturing that could allow the battery cable to contact the edge of the rear transmission mounting bracket. During normal vehicle operation the battery cable...
Certain light duty trucks may have had the outer corrugated protective conduit for the battery cable worn through at the rear transmission mounting bracket and the battery cable may rub against the edge of the third frame cross member support and allow the...
On certain fifth wheel trailers, under extreme or repeated extreme side-loading of the axles, bending of the spring hangers may occur.
On certain motor homes equipped with vehicle systems' aqua-hot and hydro-hot water heaters, which use webasto burner tubes. The burner tubes do not meet specifications and could fail prematurely.
Certain 2005 my sturdibus school buses. These buses fail to comply to federal motor vehicle safety standard no. 217, "Window retention."
Certain pickup trucks fail to comply with the requirements of federal motor vehicle safety standard no. 225, 'Child restraint anchorage systems.' These vehicles have a manual air bag on-off switch to disable the front passenger air bag and do not have a...