On certain trailers, the wheels and nuts may not maintain a solid clamp due to decreased length of engagement.
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
On certain class a motor homes, the rear hitch attachment brackets that connect the hitch assembly to the chassis frame may crack at the 90 degree bend.
On certain motor homes built on workhorse chassis, fail to comply with the requirements of federal motor vehicle safety standard (fmvss) no. 101, "Controls and display" and standard no. 105 "Hydraulic and electric brake systems." Models with actia...
On certain transit buses equipped with webasto heaters, the burner tubes are made of material that does not meet specifications and could fail prematurely.
On certain passenger vehicles, there is a possibility of xenon headlamp coating degradation over time. The luminous transmittance of the headlamp may decrease over a period of time.
On certain motorcycles, the throttle twist grip may not return to the fully closed position due to metal to metal contact or debris between the throttle twist grip and the handlebar.
On certain buses, an incorrect window retention clip was installed allowing the emergency exit window to open with little outward force.
On certain trucks, the brake master cylinder piston cups may have been manufactured with a defect in the rubber surface. Residue may have invaded the piston cups during the master cylinder manufacturing process. The residue could stick to the cups and cause...
On certain minivans, the multifunction switch may develop an open circuit condition in the stop lamp or hazard lamp circuit that results in the stop lamps and hazard lamps being inoperative.
Certain passenger vehicles fail to conform to the requirements of federal motor vehicle safety standard no. 225, 'Child restraint anchorage systems.' The child restraint lower anchors in the center rear seating position are located approximately 90mm behind...
On certain class b and class c motor homes, the spare wheels contain an incorrect offset. The center of the wheel was welded in the wrong position.
On certain passenger vehicles built with electronic traction control, the rear brake line may chafe due to contact between it and a floor pan stiffening rib, and a brake fluid leak may occur.
On certain motor homes built on workhorse chassis, fail to comply with the requirements of federal motor vehicle safety standard (fmvss) no. 101, "Controls and display" and standard no. 105 "Hydraulic and electric brake systems." Models with actia...
On certain transit buses, the front axle stops and the power steering gear hydraulic limit valves were found to be out of adjustment. The drag link may experience permanent deformation due to the steering load.
On certain motorcycles, the oil cooler delivery and return hose could leak oil.
On certain fifth wheel trailers, the dimmer switch may have been wired with reverse polarity. This will cause the lights on the switched circuit to either not function at all or the dimmer switch will not dim or shut off the lights.
On certain travel trailers and fifth wheel recreational vehicles, during production it was discovered that the furnace may not be secured and the gasket that seals the furnace to the floor duct system may be missing.
On certain trucks equipped with webasto heaters, the burner tubes are made of material that does not meet specifications and could fail prematurely.
Certain fire trucks fail to comply with the requirements of federal motor vehicle safety standard no. 207, 'Seating systems.' The seat tether restrains the seat during pull testing as the suspension components are not designed to restrain the seat on their...
On certain motorcycles, the defect involves a water leak around the fuel pump that is integrated within the fuel tank. An o-ring seal attached to the pump's electronic housing does not meet specifications and water can bypass this seal and contact the pump...