Latest vehicle recalls

Vehicle description: school bus. Some forward handrails with outward opening entrance doors were built with the hand rail mounting too close to the engine cover. Certain clothing articles such as draw strings can become lodged in the forward handrails at...

Vehicle description: passenger vehicles. The accelerator cable may have been manufactured with a burr on or near the end of the cable sleeve interior. This burr could fray the core wire resulting in the accelerator not returning to idle when the...

Vehicle description: certain 4-wheel drive pickup trucks and sport utility vehicles equipped with abs (antilock braking system) manufactured from september 1989 through august 1996. Under certain driving conditions the switch which signals the abs system...

This is not a safety recall in accordance with the safety act. However, it is deemed a safety improvement campaign by the agency. Vehicle description: certain light duty pickup trucks, sport utility vehicles, or minivans equipped with 3-sensor abs...

Vehicle description: minivans. Due to the inappropriate shape of the linkage in the rear door lock controller, accumulated dust may prevent the door lock mechanism from functioning properly, causing incomplete locking of the door when the childproof locking...

Vehicle description: pickup trucks equipped with gasoline engines and manual transmissions. The underbody hydraulic clutch line heat shield is too short, allowing the plastic clutch line material to be directly exposed to exhaust temperatures. It is...

Vehicle description: minivans. The left hand windshield wiper pivot drive arm was not mechanically staked to the pivot shaft.

Vehicle description: trucks assembled with skf level 2 truck hub units (thu) received from meritor. These hubs can fatigue crack.

Vehicle description: heavy duty trucks equipped with caterpillar engines and eaton autoshift transmissions. The engines can stall because of software problems.

Some of these vehicles with the key in the "on" position, exhibit a condition in which the antilock brake system (abs) motor shorts to its case and grounds through a flexible brake fluid pipe.

Vehicle description: passenger vehicles equipped with automatic transmissions. The automatic transmission pressure control solenoid valve seals do not remain sufficiently elastic, resulting in transmission fluid leakage. This leakage can result in...

Vehicle description: minivans equipped with engines supplied by ford motor company cleveland engine plant. These engines are installed with fuel injectors that do not match the lower intake manifold

Vehicle description: transit and school buses equipped with cummins isb or caterpillar 3126 engines. A decal that warns of the danger of using ether or other starting fluids in the engine air intake system was omitted. The label should be located on the...

Vehicle description: transit and school buses equipped with electronic engines. The bottom edge of the accelerator pedal can catch on the floor mat when the pedal is fully depressed. This does not meet the requirements of fmvss no. 124, "Accelerator...

Vehicle description: transit and school buses equipped with air suspension driver seat. Tether belts used to anchor the seat belt assembly to the floor were not installed on buses equipped with an air ride driver seat. This does not meet the requirements...

Vehicle description: school and transit buses built on general motors chassis. To install the new aluminum minotour body, two fuel tank strap fasteners were loosened. Re-tightening these fasteners can result in loss of clamp load, resulting in the fuel...

Vehicle description: school buses. Restraining barriers and reinforcement plates may be installed incorrectly. Nuts used to secure the plate the floor may be missing or the reinforcement plate may be mounted in a non-standard location. This does not meet...

Vehicle description: trucks equipped with tuftrac suspensions. The rear suspension axle clamps can fracture, allowing the rear axle to shift.

Vehicle description: motor homes equipped with air suspensions. The front wheel spindle bearing may have excessive preload due to improper end play settings.

Vehicle description: motor homes equipped with air suspensions. The front wheel spindle bearing may have excessive preload due to improper end play settings.