Latest vehicle recalls

Staples were used to fasten the step box on the rear corners instead of screws.

Air system blockage in the air dryer occurs degrading the moisture removing capabilities of the dryer when the vehicle is operated in a cold environment and moisture accumulates and freezes in the air dryer or in the line between the dryer and the air system...

Motorcycles do not conform to the requirements of fmvss no. 120, "Tire selection and rims for vehicles other than passenger cars." The rims do not contain the required designation information.

These vehicles fail to conform to fmvss no. 124, "Accelerator control systems." At low temperatures, excessive friction can occur in the accelerator pedal assembly.

Vehicles fail to conform to fmvss no. 210, "Seat belt anchorages." The center rear seat lap belt was improperly routed.

The upper ball joint nuts were under-torqued resulting in improper seating in the steering knuckle.

The international horn emblem is missing from the leather steering wheel cover. This does not meet the requirements for fmvss no. 101, "Controls and displays."

The wooden convenience table located in the living room area of the motorhome was not securely attached to the floor allowing movement during vehicle transit.

The wiring to the breakaway switch located on the park trailer a-frame was incorrectly installed. This switch activates the trailer brakes if the park trailer becomes disconnected from the tow vehicle during towing.

The nuts attaching the rear axle bearing oil seal retainers and brake backing plates to the rear axle housing may be under- torqued causing these units to loosen or fall off.

The air line connections were incorrectly installed on these trailers causing the air brake application and release times to be slower than required by fmvss no. 121, "Air brake systems."

During testing of fmvss no. 207, "Seating systems," the seat base deforms allowing the seat back anchorages to detach from the floor. This does not meet the requirements of fmvss no. 207.

The side stand spring plate on the retractable side stand can break allowing the side stand to drop and possibly hit the ground while the vehicle is in motion.

The spherical portions of certain lower ball joints had finished surfaces that were not smooth causing friction with the surface of the ball joint cap.

An overstatement was made of the vehicle load capacity and designated seating capacity on the tire information placard. This does not meet the requirements of fmvss no. 110, "Tire selection and rims."

The lower steering column linkage heat shield can come in contact with a brake hydraulic system pipe mounted to the engine assembly, eventually resulting in a hydraulic fluid leak.

Air system blockage in the air dryer occurs degrading the moisture removing capabilities of the dryer when the vehicle is operated in a cold environment and moisture accumulates and freezes in the air dryer or in the line between the dryer and the air system...

Residual engine heat can cause premature deterioration of the fuel hose causing the hose to leak. Also, removing and reinstalling the deteriorated fuel hoses increases the likelihood of a leak.

It is possible to move the shift lever into the reverse gear position, remove the ignition key, and still have the transmission in neutral, or, to accidently disengage reverse by striking the gear lever.

Moisture can follow the electrical harness and enter the pressure switch connector causing corrosion and malfunction of the switch.