Latest vehicle recalls

The trailer hitch attaching bolts were not tightened to the specified torque. This can lead to loosening and subsequent breakage of the fasteners.

These vehicles do not meet the rear impact test requirements of fmvss 301, "fuel system integrity."

The front fuel lines have a section of flexible hose that is susceptible to cracking which can allow fuel leakage.

The front fuel lines have a section of flexible hose that is susceptible to cracking which can allow fuel leakage.

A weld in the seat rails was not made, increasing the risk of fatigue cracks forming around the attachment bushings on the height adjustment mechanism, causing the possibility of the height adjuster breaking in a rear end collision and allowing the seat to...

A number of brake light switches have an oval-shaped piston which can get stuck under certain conditions. Other switches were mounted so that both locking tabs are not completely engaged in the mounting bracket. If one side is not engaged, the switch is...

Vehicle description: multipurpose passenger vehicles equipped with plastic fuel tanks. The fuel tank sending unit gasket can crack causing fuel and fuel vapor leaks.

The liquid propane gas (lpg) pipes at the rear of the vehicle are routed so they contact the tag axle during vertical movement. This contact can rupture the lpg pipe and allow lpg leakage.

The heater control valve stem does not meet the material specifications. High coolant temperatures can cause the stem to leak.

The offset toe adjusting pin can fracture under conditions such as torsional loads, flexing motion, impact loads, and overtorquing.

In a heavily loaded vehicle, while in the cruise control mode, the throttle may not reduce immediately when the load on the engine is decreased (such as when the vehicle crests a hill.) This can result in increased vehicle speed without prior warning.

The second row, right hand shoulder belt can become "pinched" between the seat and the door frame pillar trim. The shoulder belt may not retract properly, which does not comply with the requirements of fmvss no. 208, "Occupant crash protection." The 1994...

The brake fluid initially installed by the manufacturer is contaminated.

The front suspension track bar has inadequate fatigue strength.

Significant wear can develop on the low and reverse clutch preventing the park pawl from engaging. This can prevent a "no park" condition to occur while the engine is running, causing unintentional movement of the vehicle without operator action. (The "no...

A decal warning of the potential danger in using starting fluid to start the engine was omitted.

The radiator cap pressure relief valve release pressure is set too high. This can cause the coolant to reach temperatures that exceed the thermal design limits of some components of the coolant system. Should this occur, engine coolant can leak collect on top...

In some vehicles, the manufacturer's protective internal coating of the electronic crank angle sensor does not meet specifications, which can cause an open circuit at high operating temperatures. This can cause the vehicle to stall.

Air brake supply lines are reversed at the brake treadle valve. This can cause the modulated spring brake feature on the rear axle brake to be inoperable. In the event the rear brake supply reservoir were lost, this could result in loss of brakes without...

The manufacturer's certification label and/or the driver air bag advisory label may be missing from the vehicles, which does not conform to the requirements of 49 cfr 567.