The absence of a fastener may allow a flexible rubber brake hose to come into contact with the exhaust manifold. The rubber hose may melt and cause a loss of brake fluid and braking power to the rear axles of the vehicles.
Updated daily from NHTSA
Latest vehicle recalls
38 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
Under certain vehicle operating conditions, the governor weight retainer in the injection pump may fail. The throttle valve could stick, preventing return to idle and shut down of the engine by the driver.
The throttle return springs on the affected vehicles provide less than the required torque, causing a sluggish return of the throttle to the idle position after the accelerator pedal is released. This fails to comply with the requirements of federal motor...
The pitman arm retaining bolt may not have been tightened to the required specifications due to a design change. Inadequate retention of the bolt to the output shaft could allow the pitman arm to loosen.
The floorboard opening and the steering column seal bracket may not allow sufficient clearance for the shaft to turn freely in the center of the bracket/seal. The pinch bolt in the column yoke may bind or lock the column against the bracket, allowing little...
The right hand clearance lamp is obscured, from certain angles of vision, by the in-line precleaner air cleaner cap. The involved vehicles fail to conform to federal motor vehicle safety standard no. 108, "Lamps, reflective devices, and associated equipment".
Incorrect information on tire placards constitutes a failure to comply with federal motor vehicle safety standard no. 110, "Tire selection and rims". The information concerning tire sizes and inflation pressures is applicable to both two and four door sedans...
There may be a missing duct collar between upper and lower air conditioner units. On units with optional heating capabilities, if the blower fails, the excess heat produced will not be contained in the area of the safety limit switch.
The area surrounding the gasoline filler pipe shroud may not be properly sealed. This may allow gas vapors to travel into the interior of the coach when refueling.
The hydraulic brake fluid used in certain vehicles may fail to comply with the brake fluid boiling point requirements of federal motor vehicle safety standard no. 116, "Motor vehicle brake fluids". Braking efficiency may be reduced and vehicle stopping...
There may be an insufficient permanent lubrication in the buckle/release mechanism of the type 2 seat belt assemblies. This may cause front seat occupants to have difficulty in fully fastening seat belts, although they may seem to be fully fastened.
The seven-blade engine cooling fan is subject to fatigue cracking during normal operation. Portions of the blades may separate without prior warning.
An air brake hose fitting beneath the floor of the subject vehicles may rub against the rotating steering drive shaft, eventually causing the shaft to fracture. This condition could exist if a mechanic failed to orient the threaded 90 degree elbow fitting in...
Prolonged contact with road salt may, under certain conditions, cause serious rusting. This can weaken certain undercarriage components: lateral suspension arms, front crossbeam and strut coil spring lower supports.
Certain vehicles could be subject to a fuel leakage in the engine compartment due to the possibility of deterioration in the integrity of the high pressure fuel hose connections.
Due to insufficient grounding of the internal ignition distributor parts, the ignition could misfire. This could adversely affect vehicle driveability and longevity of the distributor components.
The side overhead bunk mounting brackets may have been improperly installed.
Steering shaft binder bolts on certain vehicles are either loose or over-tightened. Either condition can lead to a separation of the steering shaft from the steering column, even if the factory installed bolt has been properly retightened.
The owner"s guide may contain an error in the wheel lug nut torque specification chart. Incorrect information could result in improper torque of the lug nuts during wheel replacement. Lug nuts could come loose during vehicle operation.
The spare wheel is one inch wider than the maximum approved rim width and fails to comply with federal motor vehicle safety standard no. 120, "Tire selection and rims for motor vehicles other than passenger cars".