Latest vehicle recalls

Vehicles may not conform to federal motor vehicle safety standard no. 110, "Tire selection and rims". The tire rim size was omitted on the existing label.

The involved vehicles may have been assembled with the power steering hose incorrectly routed. The power steering hose may then contact the exhaust manifold, resulting in deterioration and eventual failure of the hose and leakage of power steering fluid onto...

On certain vehicles, the right and left hand rear brake backing plate attachment bolts may not have been tightened to the correct specifications. Backing plate bolts may not be able to withstand the loads experienced during truck shipment. If the bolts loosen...

The involved vehicles may have been assembled with a brake pedal support bracket which was designed for use in diesel engine vehicles. The incorrect bracket may cause the service brakes to remain partially applied, resulting in brake overheating and reduced...

The involved vehicles have emergency exit labels of less than the two inch height required by federal motor vehicle safety standard no. 217, "Bus window retention and release".

The possibility exists that the mounting collar for the electric fuel pump, submerged in the fuel, could partially detach from the top of the tank and cause a fuel leak.

Some of the involved vehicles have been released without the seats being properly fastened to the floor and seat rail of the vehicle. This fails to comply with federal motor vehicle safety standard no. 222, "School bus passenger seating and crash protection".

The involved vehicles may start in reverse gear. This does not comply with federal motor vehicle safety standard no. 102, "Transmission shift lever sequence, starter interlock, and transmission braking affect". Some of these vehicles may be equipped with a...

Certain vehicles were equipped with front brake hose assemblies that were incorrectly manufactured by the supplier. These assemblies, both rh and lh, were incorrectly built with the fittings misoriented by 90 degrees. This could cause chafing of the brake...

Certain vehicles may not comply with federal motor vehicle safety standard no. 12I, "air brake systems". This requires the air tank capacity to be at least twelve times as large as the brake chamber volume, to provide adequate reserves for situations which...

On certain vehicles, the lower control arm ball joint to steering knuckle attaching nut may not have been torqued to specifications. This condition could cause the nut to back off, resulting in joint separation.

Some of the engine cooling fans on the involved vehicles may be subject to high blade stresses that can result from resonant vibration inputs occurring during normal vehicle operation.

The involved vehicles were manufactured without the midship fuel tank protective shields. As a result, they do not conform to federal motor vehicle safety standard no. 301, "Fuel system integrity", due to excessive fuel spillage upon frontal impact.

The involved vehicles do not have a protective fuel tank shield. As a result the 137 inch and 161 inch wheelbase chassis cabs fail to conform to federal motor vehicle safety standard no. 301, "Fuel system integrity". If the above vehicles undergo frontal...

The involved chassis cabs were improperly equipped with outside rearview mirrors with a reflective surface area of twenty square inches, which does not comply with federal motor vehicle safety standard no. 111, "Rearview mirrors". This requires vehicles with...

On involved vehicles, the connection between the steering control shaft and the input shaft on the steering gear box may be defective. The yoke on the shaft may loosen, allowing the splined surfaces on the yoke and shaft to wear. Continued operation may...

On certain vehicles a bending of the frame may develop near the points of attachment between the undercarriage and vehicle body. This bending may lead to additional damage to interior and exterior structures of the vehicle.

Due to computer input error which resulted in an incorrect build schedule, some vehicles were shipped without the required exhaust system heat shields. When the vehicle is idled over an extended period of time, a missing exhaust heat shield may result in...

The auxiliary heater"s exhaust pipe is mounted in a downward position toward the ground.