- The problem
- On certain trucks built with 8,000 or 6,000 pound front axles and four-piece spindle nut sets, premature front ,wheel bearing wear may be caused by inconsistent bearing endplay adjustment.
- The risk
- If allowed to progress, the front wheel assembly may separate from the vehicle, which could result in a crash.
- The fix
- The dealers will replace the front axle oil seals and hub cap gaskets on both sides. The recall began september 7, 2004. Owners should contact freightliner at 1-800-547-0712.
Suspension
2000 Sterling Acterra Suspension problems
No owner has filed a complaint about the 2000 Sterling Acterra's suspension with NHTSA. Broken springs, struts, control arms, ball joints, noises and alignment that won't hold.
- Complaints
- 0
- Recalls
- 5
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Suspension recalls for the 2000 Sterling Acterra
- The problem
- On certain trucks equipped with truck hub units manufactured by skf exclusively for use on arvinmeritor's ff98x series non-drive steer axles, the hub unit bearings can wear prematurely.
- The risk
- Seizure of the bearings can cause wheel separation or wheel end fire.
- The fix
- Dealers will replace both front hubs. Owner notification is expected to begin on or before september 20, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact freightliner at 1-800-547-0712.
- The problem
- On certain trucks, the welds that attach the rear suspension control rod brackets to the axle housing may not meet specifications.
- The risk
- A weld could fracture, increasing the risk of a crash.
- The fix
- Dealers will inspect the rear suspension bracket welds to determine if they meet specifications and re-weld if necessary. Owner notification began july 31, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact freightliner at 1-800-547-0712.
- The problem
- Vehicle description: heavy duty trucks equipped with chalmers 1000 and 800 series suspension kits. These suspension kits may have insufficient penetration of the weld attaching the torque rod eye to the torque rod tube.
- The risk
- Failure of the weld could result in separation of the eye and tube, causing a lock of axle retention, which could result in loss of vehicle control.
- The fix
- Dealers will replace all chalmers fixed torque rods on these vehicles. Owner notification began march 14, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact freightliner at 1-800-547-0712.
- The problem
- Vehicle description: heavy duty trucks equipped with arvinmeritor mfs-8 series front axle assemblies. The wheel bearing nut adjustment assembly may 1) restrict a complete lubrication fill at assembly and/or 2) shear the spindle perforated washer's locking tab (located in the inside diameter of the washer) when tightened. If the washer tab is sheared, tightening of the outer spindle nut may cause the bearings to be excessively preloaded rather than the intended .001" - .005" End play. Either of these conditions may cause premature wheel bearing failure.
- The risk
- A premature wheel bearing failure could result in separation of the wheel assembly from the vehicle and result in loss of vehicle control.
- The fix
- Dealers will remove and replace the front axle spindle nuts and washers with a redesigned system.
Suspension complaints
No complaints about this area yet.
Sterling Acterra suspension complaints by year
Acterra suspension problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data