After purchasing a 2002 subaru forester, the vehicle was driven for a very short period of time prior to noticing that the front end of the vehicle began to feel loose and unstable while steering, and the vehicle began to pull to one side while accelerating and braking. After noticing the instability and swaying action, I conducted cursory inspections of the front end and suspension areas of the vehicle. As a result of inspections, I didn't notice anything wrong with the undercarriage. While driving the vehicle on...
Read the full complaint
20 september 2014, without warning, the right front lower control arm broke. It could be observed that there was a failure in the weld between the hanger bracket and the main portion of the control arm. After the control arm broke, it caused the control arm to move towards the rear of the vehicle; it caused the right front tire to slam abruptly into the rear portion of the tire well; it then caused the right front tire to lock up, which subsequently caused the tire to immediately begin to skid. Contributing factors which minimized results: vehicle was only traveling at about 45 mph; it occurred on secondary road; road was straight and level; there was no oncoming traffic; and road surface was dry. There was additional vehicle damage. Upon checking the recalls for the 2002 subaru forester, I discovered that the 2003-2008 foresters were recalled for this exact reason (recall id # 70673.) There were other additional recalls as well for similar issue. After contacting subaru customer service, I was advised that they would not cover the front lower control arm under the recall even though the characteristics of the recall were the same. I believe that the failure of the control arm is very obvious and it should be covered similar to the other recalled years. I would be happy to provide pictures of the front lower control arm failure. Thank you. *Tr