My 2003 Sequoia was in the garage for a check on the brakes. I also asked them to check the frame for any rust issues, because I had previously been concerned about it earlier. They reported to me that the car should be off the road because the rust in the frame was so severe. They said they would not put it up on the lift anymore because it could break in half. The stabilizer was barely connected at one end. There were holes completely through the frame at several places. I know from my research that Toyota issued safety recalls for 2003 Sequoia and Tundra vehicles. This an issue that Toyota should repair.
Body, doors & structure
Toyota Sequoia Body problems by year
509 complaints filed with NHTSA about the Toyota Sequoia's body, doors & structure. Doors, hoods and latches, frame rust, sunroofs, leaks, trim and structural failures.
Body complaints by model year
Latest Sequoia body complaints
The contact owns a 2004 Toyota Sequoia. There was an abnormal rattling sound detected in the front area. The vehicle was shaking. No warning lights were illuminated. The vehicle was taken to an independent mechanic who determined that the frame was completely rusty and unsafe to drive. The vehicle was taken to the local dealer to have the frame checked, and it was determined there was minor rust detected. The vehicle was not repaired. The contact vehicle was taken to another local dealer, Crestmont Toyota...
Read the full complaint
Parts · Crestmont Toyota Service, 730 NJ-23 N, Pompton Plains, NJ 07444, who determined there was rust detected but was not repaired. The contact wrote a letter to the manufacturer. The failure mileage was approximately 198,000.
Tail gate handle broke (second time). dealer fixed the first time. If I have a flat tire, I can't get to the spare tire.
Rust! Frame completely rusted, even though the CRC was applied back in 2013.
The contact owns a 2004 Toyota Sequoia. The contact stated that while completing an inspection and emissions test on the vehicle, the mechanic informed the contact that there was severe rust on the rear subframe of the vehicle, near the control arm, and several other areas on the subframe. The contact stated that there were several holes on the subframe caused by the extreme rust. The dealer was not contacted. The vehicle was not repaired. The manufacturer was not informed of the failure. The failure mileage was approximately 203,000.
The rear gate door or Deck lid will not open. with either key, or any other method. Every time this occurs, I have to take to the body shop to open and pay $200 for them to open it. They have to climb to the back, dismantle the rear door panels from the inside and undo some mechanisms to open it finally. The shop stated that they have had this problem with these Sequoias many times.
I own a 2001 Toyota Sequoia SR5, which I purchased new in Colorado and moved to Virginia in 2004. I received a Toyota Limited Service Campaign Program notice in 2013 about excessive corrosion on the frame. Alexandria Toyota inspected the vehicle and applied a Corrosion-Resistant Compound to the frame. They also replaced the spare tire carrier assembly due to rusting. Over the years, I've had mechanics mention the rust on the frame but Toyota never issued a recall on the 2001 Sequoia. In November 2024, the...
Read the full complaint
following dashboard lights remained on while driving: Vehicle Skid Control (VSC) OFF, VSC TRAC and Brake Lights. I took it to Steven's Auto Clinic in Alexandria. They found low brake fluid levels were causing the brake system failure. The brake pipes are leaking due to heavy rust. In addition, rust was destroying the under carriage. The brake system and frame would require extensive maintenance. They warned me NOT to drive the car. They refilled the brake fluid to allow me to take the car home. Reading the Complaints under Structure on the NHTSA website, dozens of customers over the years mention serious rusting on the frame of their 2001 Sequoias. I believe Toyota had a recall to replace the frame on the Tundra but never included the 2001 Sequoia even though it was built on the Tundra frame. I now have a vehicle I can't drive, due to safety concerns, and I can't sell, except for parts. The Sequoia should have been included in the Tundra recall. Toyota needs to be held accountable. I can provide any paperwork for my 2001 Sequoia including the Limited Service Campaign Program notice and the repair order from Stephen's Auto Clinic if necessary. I can also provide the vehicle for inspection.
The contact owns a 2007 Toyota Sequoia. The contact stated while the vehicle was parked, the contact noticed that the rear subframe was fractured. The vehicle was taken to an independent mechanic where it was determined that the rear subframe needed to be replaced. The vehicle was not repaired. The vehicle was taken to the dealer but was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 138,000.
See attached document for complaint.
See attached document for complaint.
TOYOTA frame is falling apart due to the use of faulty metal to manufacture those frames they ran a limited service campaign to replace some of the frames and they denied many other owners that right please help by telling TOYOTA North America to take care of this very hazardous issue thank you
The contact owns a 2001 Toyota Sequoia. The contact stated that the vehicle was at the dealer for a diagnostic test; however, the dealer declined to perform the diagnostic test, stating that the sub frame was unstable, and an unknown recall campaign had expired. The manufacturer was made aware of the failure. The contact stated the dealer informed him there was a recall for the sub frame, however, the recall had expired. The failure mileage was unknown.
Component/System Failed: The frame of my 2002 Toyota Sequoia has severely rusted, resulting in a gaping hole. It is available for inspection upon request. Safety Risk: The rusted frame jeopardizes my safety and renders the vehicle unsafe for use. Confirmation: A mechanic has confirmed the rust issue. Manufacturer Inspection: Toyota has not inspected my Sequoia's frame. Warning Signs: There were no warning lamps or messages related to frame rust prior to the failure; it became evident during my recent inspection. ...
Read the full complaint
The gaping hole in my Sequoia's frame is not due to normal wear and tear but rather Toyota's poor manufacturing practices. Shockingly, Toyota issued a "limited service campaign" for similar rust issues in other vehicles, but I was never informed. This lack of transparency is unacceptable. It is clear that Toyota's decision to implement a limited service campaign, rather than a comprehensive recall, reflects a blatant disregard for the safety and satisfaction of its customers. By prioritizing cost-cutting measures over ethical responsibility, Toyota has failed to uphold its duty to consumers and the people who sustain its business. Toyota's actions have revealed a disturbing trend of prioritizing profits over people. The company's failure to adequately address known issues with rusted frames speaks volumes about its commitment to quality and customer satisfaction. Despite numerous complaints and documented cases of frame rust, Toyota's response has been inadequate. I urge Toyota to take immediate action. Inspect and replace my Sequoia's frame promptly. Prioritize consumers over profits. Restore my faith in the brand that I once trusted.
Advance rust on car frame
Rear axle is rusted to the point where differential fluid is leaking out of the body. There is extreme rust in general which has led to the failure of multiple components such as the oil pressure sending unit. Check engine light is on. This hasn't been verified by a shop or agency, only by me. These issues were discovered shortly after purchase this year.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data