2017 Chrysler Pacifica Problems, complaints & recalls

idling as well as the acceleration happened today taking my kids to school. This vehicle should be included on the CDJR XD1 recall. This is also showing in my car overview online, but does not pull up when I called the dealership.

immediately texted the service manager at the dealership with a video of what it was doing. No Cel light only intermittent red turtle. Now fast forward to today. The dealership says the van needs a HV battery heater to the tune of over $2,000. It now has the red turtle and and the cel illuminated. This battery heater has been an extremely common issue for the pacificas and the jeeps with the hybrid drivetrain (essentially the same). There needs to be some sort of recall for this issue as the problem is common among pacifica and jeep owners with the hybrid drivetrain. P0E15 code is active currently. I have attached pictures showing the red turtle and no cel. Service manager says the cel is currently active on the vehicle along with the red turtle. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

frame. The driver's side door center roller is now showing identical cracking plastic, binding, and imminent failure. This presents an extreme risk of severe crush injuries or trapping passengers. 2. UCONNECT TOUCH SCREEN (ELECTRICAL & VISIBILITY DEFECT): The factory 8.4-inch Uconnect infotainment touch screen has suffered an internal hardware failure that causes the screen to flash and strobe violently and continuously, even during system reboots. This flashing creates an intense driver distraction and cabin blinding hazard during night driving, severely compromising road visibility. Furthermore, the failure completely disables the backup safety camera and the ability to operate vehicle defrost and climate safety controls.

disabling Electronic Stability Control, Forward Collision Warning, and Blind Spot Alerts. Most critically, the loss of network data causes the vehicle to enter "limp mode," locking the transmission in its current gear and refusing to upshift or downshift, creating a severe crash hazard in active traffic. The root cause is a physical hardware defect in the CAN-C Star Connector junction block (Part No. 68321746AA) located behind the passenger-side glovebox. The pin receptacles inside this distribution block degrade and lose tension, allowing data wires to vibrate loose. Striking the passenger-side dashboard physically reseats the pins, instantly restoring network communication, shifter lights, and transmission function. Dealerships are misdiagnosing this defect by following factory diagnostic trees that mandate replacing the functional Electronic Shifter Module (an ineffective $1,400 repair) instead of addressing the faulty Star Connector. My vehicle has been at the Chrysler dealership since initial diagnosis with no resolution, as the dealer refuses to repair the known wiring defect without first replacing the functional shifter. The sudden loss of transmission control and active safety systems due to this faulty communication block is an extreme safety hazard. Chrysler must issue a mandatory recall to replace these degraded Star Connectors.

under the warranty. There are two manufacture warranties that should apply here, but Stellantis will still not approve the release of the batter. Chrysler is using software-level diagnostic constraints to evade a safety-related powertrain warranty extension. In the meantime, I am left without a vehicle.

until may of 2026 when I was able to pay a mechanic to replace water pump and radiator. with in a week of replacing the water pump and radiator the vehicle began severely jerking and bucking particularly when accelerating from a full stop. then while driving down the road it intermittently starts bucking. I attempted to contact a local dealer however they do not have any sufficient financing programs to cover the cost of repairs and diagnosis charge. I spend 8000 on a vehicle that has barely ran and showed no symptoms or warning lights of a catastrophic failure.

3 lanes of the freeway. All of us were in danger of being hit by traffic. Van was towed to AAA service station nearby. Batteries both 98-100%. Plenty of gas at the time of the incident. AAA service station replaced the starter, but their diagnostic did not show any other problems. This did not make sense to me or to anyone else I spoke with. When I picked up van Aug 19 after being out of the state, the AAA shop recommended that I drive it, and see if further problems. I felt unsafe, not sure what to do. Decided to drive near home on neighborhood streets. Van worked ok on suburban streets for about 6 weeks, then radio died one night (worked after turning off van, opening and closing door and restarting) and interior cabin light came on repeatedly without me turning it on, on another occasion, even after I turned it off. I am taking to Chrysler dealer for additional diagnostic on Friday. Part of my delay is affordability, as the dealer will also do a diagnostic (over $300) which they say is better than non-dealer ones.

screen rebooted. I heard a clicking noise from under the hood, which I later learned was the parking pawl trying to engage. Dash screen said something about "speed too high to shift to park." Momentarily the wheel jerked hard - I think I lost power steering (if the car fully shut off I think that's what happened). I gained control and directed the car to the side of the road. I don't know what state the car was in at this point - either fully off or electrically on but no engine power. In any case, I shifted to park, pressed the on/off button and the car fully shut down. After a couple of minutes I attempted to start the car again, and it started right up with no issues. The CEL was lit, but the car drove fine. When I got to my destination about 20 miles away, I checked the battery terminals. I found that the negative terminal could be turned about a quarter turn if I used some force, but it was not what I would consider 'loose'. I still tightened the connection as much as I could, to the point that the connection was now immovable. The CEL cleared after a few cycles of turning the car on and off. A scan later showed that code P1B14 was stored. I called multiple Chrysler dealerships and each told me that they could not diagnose the problem unless it was actively acting up. The car has not malfunctioned since the incident four days ago. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

inspected by the manufacturer, police, insurance representatives or others. No, there weren't any warning lamps, messages or other symptoms of the problem prior to the failure, and it occurs when the steering wheel is at 11 or 1 o'clock at speed.

have not taken this to a dealer yet, there are numerous articles online clearly stating this is a very dangerous issue-specifically with my 2017 model year. I see no warning lights that accompany this behavior. And that makes it all the more dangerous. Without any awareness of the issue, it's a lot more probable to experience the behavior and cause an accident.

curve. When the steering wheel releases from the sticking position, the sudden change in resistance can make it difficult to maintain smooth, controlled steering. The problem has become noticeably worse and more frequent over the past few weeks. We had the vehicle inspected by an independent mechanic, who advised that the power steering motor needs to be replaced and recommended that we take the vehicle to an authorized Chrysler dealership. The Chrysler dealership (Lewis Chrysler Dodge in Fayetteville, AR) inspected the vehicle and informed us the steering rack and pinion assembly and both tie rod ends need to be replaced and quoted us a cost of $4,450 for parts and labor. After researching the problem, we discovered NHTSA Preliminary Evaluation PE25009 involving 2017-2018 Chrysler Pacifica vehicles. The symptoms described in the investigation closely match what we have been experiencing, including intermittent steering resistance during gradual turns and the need to apply additional steering force to overcome the resistance. Because the condition has been getting worse, we are concerned about the possibility of a total loss of power steering while driving. We cannot afford the quoted repair cost, and because of our safety concerns, we have stopped driving the vehicle. We are submitting this complaint so that our experience can be documented and considered part of NHTSA's ongoing PE25009 investigation.

battery pack sensor module), U0412-00 (invalid data received from battery energy control module A), and current code P1D43-00 (internal control module shut off test monitoring time error). With these relating to the battery pack control module ("BPCM") and hybrid control processor, it is quite apparent that there is an issue with the BPCM and that the lack of communication and errors on the shut off test monitoring that the BPCM is malfunctioning which could cause a number of issues, such as a fire per safety recall 73B. I was told by the manufacturer that there is a 2-year period to remedy safety recall work. As this was a software update, it would appear that the software is now identifying a potential danger with the BPCM. Per that recall "...A folded or torn anode tab may result in the generation of lithium by-product over time. This defect, along with a second unidentified factor, may lead to an internal short within the pack and may result in a vehicle fire. A vehicle fire may increase the risk of injury to occupants and persons outside of the vehicle, as well as property damage. " Without proper communication (as stated earlier), I expect that my vehicle is still at significant risk. However, the dealership I've brought it to is requiring me to pay for battery pack replacement and has charged me a diagnostic fee. This while they have labeled the issue a "failed high voltage battery". My request for recall coverage was dismissed.

2026, and as of 10/1/26 has been out of service for about 6 weeks. The dealer has an open Chrysler STAR technical support case (102974656) seeking approval to replace the high-voltage battery, and the process has involved repeated requests for additional testing. I have been given loaner vehicles during this time but am approaching the mileage limit on the second. The vehicle has about 220,000 miles and I have owned it since August 2017. It has no open recalls. It previously received recall repair work on the hybrid system, including the power inverter module recall (Chrysler T34 / NHTSA 17V-371), which included reprogramming of the battery pack control module. I understand this model has also been subject to other high-voltage battery recalls. I am reporting this because a high-voltage contactor failure that leaves the vehicle unable to start or move can strand occupants, in this case in an underground parking structure, and because the repair has been delayed for more than 6 weeks. The root cause has not yet been determined by the dealer or manufacturer. I would appreciate NHTSA tracking this failure alongside other Pacifica Hybrid high-voltage battery complaints.