On October 22, 2026 at 7:55pm I was slowly pulling into a parking spot at our community building applying the brake when the engine started rapidly accelerating causing the car to jump over the curbing even as I continued to press on the brake pedal. I wasn't able to stop the vehicle before it crashed into the community building wall. The engine was still racing but the vehicle being lodged in the wall and corner support kept the vehicle from going further into the building. I was finally able to shut off the engine and luckily for me the airbag system didn't deploy.
Live from NHTSA
Latest vehicle complaints
3,679 complaints filed by owners in the last 30 days. Newest first, as NHTSA publishes them.
About 3 years and 3 months after a Power Control Module reflash was done in March 2021 under the Customer Satisfaction Program (CSP) 20B27, vehicle was brought to Ford dealership on 06/07/2024 with mileage at 79,730 for multi point inspection due to vehicle runs rough and hard time accelerating. Diagnostic code was P0316. Service tech recommendation was to replace engine for $14,000.00 including parts and labor (declined recommendation). Brought vehicle to another dealership but found no codes. Instead replaced...
Read the full complaint
engine motor mounts, sparkplugs, and air filter due to noticeable vibrations. Dealership service tech inspected engine but found no abnormal findings. Went to another Ford dealership on 10/08/2026 to check Code P0299 that appeared on OBD test and for further inspection due to sluggish acceleration from full stop and slows down going uphill. Ford's guidance stated that torque converter failing due to mileage, acceleration/power loss from dead stop. Recommended fix was to replace the transmission for $8,461.03 (declined recommended service). On 10/23/2026, I picked up my vehicle from the dealership. During my return journey from the dealership, I encountered the same sluggish acceleration. A safety hazard that is attributed to a malfunctioning torque converter, a know problem for Ford. Consequently, Ford dispatched CSP 20B27 to assist in safeguarding the transmission converter from overheating. Regrettably, this intervention proved ineffective in mitigating the problem. Ford issued CSP 20N07 to extend warranty coverage of the automatic transmission torque converter for 12 months from RO date which in my case, RO date on CSP 20B27 was 03/19/2021. Despite the 12-month eligibility period not being met, my vehicle should have remained covered. Initially, Ford was aware of a transmission torque issue and was attempting to resolve it through CSP 20B27 and CSP 20N07. Currently, mileage is at 85K miles but I'm hesitant to drive due to safety concerns.
When traveling down a road the CMBS will detect an object at times in your path of travel. Other times for example I was traveling i95 North in the middle lane, car detected a vehicle to my left and then indicated the car was attempting to cut me off thus activating breaking system, there wasn't any vehicles to my left or right. There was vehicles directly behind me and to my far right lane. Such issues have happened multiple times, I've spoken to 3 different Honda dealerships regarding this matter, I've been unsuccessful in getting this dangerous issue resolved. I'm told the technician would have to replicate the issue, well this CMBS issues happens randomly without any prior warning.
Multiple times the vehicle has allowed lane crossing with no warning neither actual assist or beep into oncoming traffic. A vehicle abruptly stopped approximately 75 feet ahead of me the vehicle did not respond and I did have to slam my brakes. I was able to stop with only 3 feet between me and the stopped vehicle. Automatic collision avoidance neither attempted to stop nor gave any warning. Blind spot monitor allows lane change with turn signal on and a vehicle in blind spot again with no warning. I was on the...
Read the full complaint
freeway and the center lane when this happened, I was merging into right lane. Starlink 11.6" media center freezes and lags. Dealership service department claims everything is working fine. Service department claims nothing wrong even this was witnessed by a dealership employee and the dealer manager took my car to the service department after the employee explained these problems were seen with her in the vehicle.
The UA80 transmission on my 2018 Toyota Highlander Limited AWD began the "death whine" at 110,000 miles. Brought it directly to a Toyota dealer and was told the transmission needed full replacement. Seems to be very common with these transmissions and there's a service bulletin that's advertised from Toyota (our VIN number was not covered despite the exact same issue described to a T).
Component or System Failed: Unibody structural frame / Front chassis suspension and crumple zone architecture. Description of the Incident and Safety Risk: A structural repair was executed on this vehicle involving an improper "rough pull" on a frame rack/jig rather than replacing the compromised structural components to OEM specification. The auto body facility failed to restore the vehicle's unibody structural integrity. Misaligned body lines and underlying unibody damage remain uncorrected, severely degrading...
Read the full complaint
the vehicle's engineered crumple zones. This creates an immediate, severe safety risk. Because the high-strength steel and structural collision-energy management features have been altered and weakened without proper sectioning or component replacement, the vehicle's structural performance in a subsequent impact is entirely compromised. This significantly elevates the risk of severe cabin intrusion and catastrophic structural failure in a future accident, endangering the safety of all occupants. Confirmation and Documentation: The underlying structural and unibody deficiencies have been identified and documented via visual inspection, initial estimates, subsequent supplement records, and detailed parts lists
Vehicle Information: Year/Make/Model: 2017 Hyundai Elantra Value Edition Mileage: ~135,000 miles Engine: 2.0L Nu 4-Cylinder VIN: [[redacted]] Incidence Summary: Engine internal failure, metallic debris/shavings found in oil, severe knocking noise, high risk of sudden engine stall/failure while driving. Detailed Description of the Incident: While driving home, the vehicle began producing a loud, severe metallic knocking noise from the engine compartment. The engine continued running, but the noise persisted...
Read the full complaint
throughout the trip. Upon inspecting the vehicle, a certified mechanic removed the engine oil and discovered a significant amount of metallic debris and metal shavings inside the oil pan, indicating severe internal engine component wear (connecting rod bearing / crankshaft failure). The mechanic advised that the engine is at immediate risk of seizing or experiencing complete catastrophic failure. Safety Risk: A sudden engine failure or seizure while driving on a highway or at high speeds creates a critical safety hazard, as it can cause an immediate loss of power, loss of power steering/braking assistance, and significantly increase the risk of a crash or rear-end collision for me and surrounding traffic. Current Status: The vehicle is no longer safe to drive and has been grounded to prevent complete engine lockup or serious road accidents. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
In a rented 2022 TESLA MODEL 3 entering a right veering on-ramp, the vehicle failed to respond to driver steering inputs at normal speed. I released the accelerator and there was no degenerative braking. I applied brakes, but the ABS was violently shaking without stopping and I noticed something illuminate on the computer screen. Unable to turn the steering wheel at all, we made severe impact with the left guardrail injuring both my wife([[redacted]]) and I. The Steering Assist Reduced warning light remained illuminated after the accident and I took a picture. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The vehicle experienced a sudden loss of engine power, violent shaking on cold starts, and a low coolant warning light. A formal inspection has confirmed catastrophic internal coolant intrusion into the cylinders, requiring a complete engine long-block replacement. The official repair estimate from the shop is $9297.30 at 81,320 miles. This failure directly matches the manufacturing defect detailed in Ford TSB 19-2346 and is part of the open NHTSA investigation into 2015-2018 Ford Edge engine power loss. The threat of sudden engine failure while driving presents a severe highway safety hazard.
while driving rental the sun/moon roof exploded down on the 4 passengers. we were lucky there were no other cars around, we were driving proper speed. lucky for us, close to airport where we rented the car and returned it. was informed by supervisor at enterprise this was not an uncommon event to cars. it was to us, we started googling and found it was common.
Backup camera failed. All sensors are working but when placed on reverse no camera are working
Vehicle experienced immediate severe engine stalling, power loss, and sudden total engine shut-off while moving in live traffic on the road following the execution of NHTSA Recall Campaign MGJ (Low-Pressure Fuel Pump Replacement). The engine stall occurs when mechanical and electrical loads engage, such as the AC compressor or cabin heater at idle and while driving. Diagnostic scan confirms permanent active codes P2187 (System Too Lean at Idle) and P0451 (Fuel Tank Pressure Sensor Performance), indicating fuel...
Read the full complaint
starvation from the recalled fuel pump assembly under the rear seat. When the engine sputters or shuts off, an immediate electrical warning cascade triggers across multiple safety systems, including Brake Hold System Problem, Power Steering System (EPS) Problem, and Adaptive Cruise Control (ACC) Problem. Authorized dealership (Joyce Honda) and American Honda Corporate (Case # 166-940-04) refuse to perform a zero-cost inspection and remediation without requiring out-of-pocket diagnostic fees, creating an extreme active road hazard. Video evidence of dashboard failure recorded on-road.
While turning my steering wheel during normal operation, I heard what appeared to be a popping or snapping sound from inside the steering wheel. Immediately afterward, my horn stopped working, all steering-wheel control buttons became inoperative, and the airbag warning light illuminated with the message "Front Left Malfunction - Service Required." All these failures occurred suddenly and at approximately the same time, without any prior warning or symptoms. The instrument cluster still lights up, but I can no...
Read the full complaint
longer access the mileage display using the steering-wheel controls. The last mileage I recall was approximately 80,000 miles. These symptoms suggest a possible steering-column clock spring failure, although the exact cause has not yet been professionally diagnosed. I am particularly concerned because NHTSA recall 17V627000 previously addressed a safety risk involving the steering-column clock spring and driver's airbag system. Mercedes-Benz lists this recall as completed for my vehicle. However, the recall remedy did not routinely replace the clock spring, and my vehicle has now experienced symptoms consistent with its failure. This vehicle was also purchased as a Mercedes-Benz Certified Pre-Owned vehicle with an extended warranty and was represented as having undergone a comprehensive inspection, including safety-related systems. My concern is that a clock spring or related steering-column electrical component may fail suddenly, disabling the horn and potentially compromising the driver's airbag, even after the previous recall remedy was completed. I request that NHTSA investigate whether similar failures are occurring in other vehicles, whether an ongoing safety defect exists, and whether additional corrective action or an expanded recall may be warranted.
My 2019 Ford Expedition is subject to Ford Safety Recall 26S34 (NHTSA Recall 26V344), involving inadvertent deployment of seat-belt retractor pretensioners. The driver's-side seat-belt pretensioner has deployed, causing the seat belt to retract and lock in a position where it physically cannot extend far enough to fit around the driver. As a result, the driver's seat belt is completely unusable, and the vehicle cannot be safely operated. Ford previously issued an advance recall notice indicating that a remedy was...
Read the full complaint
anticipated by September 30, 2026. As of October 24, 2026, I have not been provided with an available remedy. I have contacted Ford Customer Service multiple times and spoken with representatives regarding this issue. Ford has informed me that because the recall remains classified as an Advance Notice, its current policy does not authorize rental vehicle assistance. The dealership has also indicated that it cannot provide a rental without authorization from Ford. I have explained repeatedly that this is not simply a vehicle awaiting a recall repair. The recalled safety component has already failed, leaving the driver's seat belt unusable. Despite these circumstances, Ford has not provided an authorized no-cost repair plan or alternative transportation assistance. I am requesting that NHTSA review this actual failure of a recalled safety component and Ford's response, as the vehicle cannot be safely driven in its current condition.
Headlight system malfunction, pre-collision system malfunction, LTA malfunction, SRS airbag system malfunction and SRS malfunction lights came on after start up.
The brake booster vacuum pump broke and caused my brakes to stop working properly while driving on the highway. There were zero warnings from the vehicle I went to press on my brake and it was stuck i luckily was able to push it down enough to safely stop
I am reporting a suspected systemic safety defect involving premature failure of the integrated LED daytime running lights (DRLs) on 2020-2026 Land Rover Defender (L663) vehicles. The DRLs reportedly fail at relatively low mileage, frequently around 50,000 miles, during normal vehicle operation. The suspected cause is overheating and premature deterioration of the integrated LED driver electronics due to inadequate thermal management. The precise cause requires investigation. This failure eliminates an important...
Read the full complaint
daytime vehicle conspicuity feature, reducing visibility to approaching motorists, pedestrians, and cyclists, particularly during rain, overcast weather, and transitional lighting conditions. Some owners report no dashboard warning when the DRLs fail, potentially leaving drivers unaware of the malfunction. Jaguar Land Rover has known about this issue since at least 2021. Its Special Service Message SSM 75479 specifically acknowledges DRL failures on 2020-2021 Defenders and documents an engineering investigation. Similar failures have subsequently been reported by owners of later model years, suggesting a potentially unresolved design defect. Because the DRL electronics are integrated into the sealed headlamp assembly, dealerships generally require replacement of the entire assembly, costing approximately $3,000 per headlight or $6,000 for both. Land Rover reportedly provides goodwill replacements selectively while requiring other owners to pay out of pocket. I request that NHTSA investigate the entire 2020-2026 Defender population, examine JLR's engineering records, warranty claims, component failure rates, and headlamp design revisions, and determine whether a safety recall and manufacturer-funded corrective action are warranted. This is a recurring failure of a factory-installed safety-related lighting system, not simply an ordinary maintenance or warranty concern.
So a month ago the car started running hot I'm unsure what the cause maybe and my reservoir has cracked. When I turn the ac or heat on the car begins to run hot as well.
Trying to turn onto the street from a parking lot the vehicle wasn't accelerating as expected and I wasn't able to turn as expected. I am taking the car in soon to be diagnosed with an issue.
Leaking inside car onto floor in front of front of passenger seat and back floor behind passenger seat. Caused very strong odor throughout car, and caused anything inside car to also have a bad smell.