Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Steering

Kenworth T680 Steering problems by year

3 complaints filed with NHTSA about the Kenworth T680's steering. Loss of power steering, stiff or loose steering, wandering, column and rack problems.

Steering complaints by model year

YearSteering complaintsCrashesInjuriesRecalls
20271000
20250003
20240001
20230001
20220001
20200001
20190001
20180001
20160001
20151000
20141000

Steering recalls

Latest T680 steering complaints

2027 Kenworth T680SteeringElectrical systemBrakes

On [redacted], while operating a 2027 Kenworth T680, VIN [[redacted]], at approximately 64 mph on [[redacted]], the truck experienced a sudden electrical and control-system failure while in motion. The steering became extremely difficult or unresponsive, and the wheels or brakes appeared to lock, creating an immediate risk of a serious collision. I was able to bring the vehicle to a stop without striking another vehicle. Following the incident, the instrument panel displayed multiple "Data Error" messages, an ABS...

Read the full complaint

warning, traction-control warning, Predictive Cruise Fault, and missing engine RPM, oil, coolant, torque and boost information. The electronic parking brake would not release even though both air systems displayed approximately 100 PSI and the transmission displayed Neutral. The truck could not be safely driven and was towed to Youngstown Kenworth Inc, [[redacted]]. The dealership has verbally advised that the ECM, or control module identified by the repair shop as the ECM, is not connecting or communicating with the truck. The vehicle remains out of service pending diagnosis and repair. The truck's manufacturing label is dated [redacted]. NHTSA recall 26V485000, PACCAR campaign 26PACD, covers certain 2027 [[redacted]] T680 tractors produced from [redacted]. That recall concerns possible oil contamination in the Power Distribution Center, which can cause loss of power to the engine, ABS, exterior lighting, windshield wipers or defrost system. I request that NHTSA document and investigate this incident and determine whether the loss of electrical communication, steering assistance and braking or wheel control is connected to recall 26V485000 or another safety defect. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Incident Steering · Electrical system · Service brakesNHTSA 11763614
2015 Kenworth T680Steering

When the engine runs hot, from hard pulls over a mountain, the power steering fluid gets so hot it boils. I lose some power steering when that happens.

Filed Incident SteeringNHTSA 11080420
2014 Kenworth T680Steering

The tie rod end disconnected from the shaft, there has been no work done to the steering since new. The pictures show that the dirt on the shaft has not been disturbed therefore this is a manufacturer defect and has not been tampered with at all. The vehicle was moving at slow speed in a parking lot. This could have been a major event at highway speed. I have contacted the manufacturer. This truck has had regular service most recent being march 12th, no sign of the defect was noticed at that time and this part was...

Read the full complaint

inspected. As you see from the picture, the part must have been wearing for a larger time period than an immediate event. This part is used by many manufacturers for their products also.

Filed Incident SteeringNHTSA 10854057

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience