Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Suspension

Mazda MAZDA6 Suspension problems by year

230 complaints filed with NHTSA about the Mazda MAZDA6's suspension. Broken springs, struts, control arms, ball joints, noises and alignment that won't hold.

Suspension complaints by model year

YearSuspension complaintsCrashesInjuriesRecalls
20183000
20165000
20154000
20145200
20135000
20129000
201151210
201043101
200976201
20082000
20075000
20065000
20054000
20044000
20039000

Suspension recalls

Latest MAZDA6 suspension complaints

2011 Mazda MAZDA6SteeringSuspension

The frame rusted through and broke where the lower control arm attaches on the passenger side. This caused an immediate pull to the right and nearly caused a wreck. The car was towed to a local mechanic shop who reported the problem. Mazda is currently not taking responsibility for this even though it was a known issue and a recall was issued for this exact issue.

Filed Incident Steering · SuspensionNHTSA 11775340
2012 Mazda MAZDA6Suspension

i went to a mechanic to diagnose a clunk and rattle at freeway speeds. i was told a huge piece of metal was loose over a rotted out subframe. i told the mechanic there was a recall for a brace or bracket passenger side of the subframe. but no open recall was showing. he stated i hope this is not the piece a Mazda dealer would provide to fix that. he said it is loose and cannot be reattached and that i need to contact Mazda. he is stating i need a new subframe and the car should have never been sold to me in that condition. and to no longer drive it since it is going to split apart

Filed Incident SuspensionNHTSA 11774673
2018 Mazda MAZDA6SteeringSuspensionAcceleration & cruise control

Got error message that said "Forward Smart City Brake Support Malfunction" slso fot "smart brake malfunction" while driving. The ac stopped, the car speedometer kept going from 50 to zero. The car died and couldn't open doors, windows. Lost steering while driving. We were able to get off road and restart and fine for 2 weeks. While at still light tonight, the car turned off. Windows were up, couldn't open door, emergency blinkers would not come on. This is very dangerous.

Filed Incident Steering · Suspension · Vehicle speed controlNHTSA 11753644
2009 Mazda MAZDA6Suspension

Rear cross member broke due to corrosion breaking off lateral arm from driver side of cross member, I may add the front crossmember was repaired due to recall for extreme corrosion not too long ago, as I research this problem I uncover many owners of this vehicle having the same issue in the northeast,even with much lower mileage.mazda should be held accountable.$3,926.62 for part alone on Mazda parts.com

Filed Incident Suspension · Unknown or otherNHTSA 11750964
2010 Mazda MAZDA6Suspension

I recently had my front subframe replaced as part of your recall, however, the rear subframe and all components attached are suffering from the exact same rust and potential component failure as the front. I was replacing my brakes today and noticed that the entire structure is on the verge of complete failure. The right rear suspension already makes unusual noises when going over even small bumps and I imagine if I were to hit a large pothole that would probably be the end of this car. I imagine all similar Mazda...

Read the full complaint

6s in the Midwest suffer from the exact same degradation and it is a major safety concern. There are places where there's chunks of subframe missing because it has rusted completely through and just disintegrated.

Filed Incident SuspensionNHTSA 11746080
2011 Mazda MAZDA6SuspensionBody, doors & structure

The contact owns a 2011 Mazda Mazda6. The contact stated that while driving at 25 MPH, the contact attempted to swerve out the way of another vehicle as she suddenly lost control of the vehicle. Due to the failure, the contact force to steer the vehicle to the left as the contact attempted to maintain control of the vehicle. The contact managed to pull over into a parking lot and called her husband for assistance. Despite the failure, the contact managed to drive the vehicle home despite the vehicle being...

Read the full complaint

extremely difficult to maneuver. The contact's husband managed to drive the vehicle to a local mechanic, who determined that the front subframe had failed due to excessive corrosion of the subframe. The mechanic then informed the contact of NHTSA Campaign Number: 19V323000 (Structure, Suspension); however, the contact was informed that her vehicle was not included in the recall. The manufacturer was notified of the failure where they confirmed that the vehicle was not included in the recall. The vehicle remained in the mechanic's possession and had yet to be repaired. The failure mileage was 115,000.

Filed Incident Suspension · StructureNHTSA 11738066
2009 Mazda MAZDA6Suspension

The rear subframe rusted out and my control arm broke off! This is extremely serious and because there is no recall I'm going to have to buy an another vehicle. Please issue a recall. I've read forms about this and many others have had the same issue with the rear subframe corroding and rotting out.

Filed Incident SuspensionNHTSA 11734456
2010 Mazda MAZDA6Suspension

I looked up recalls on my vehicle and it states that The 2011 Mazda6 is part of a recall (NHTSA 19V-323, Mazda 2818I) covering 2011-2013 models for front cross member (subframe) corrosion due to insufficient rust protection . In salt-belt states, this corrosion can cause the lower control arm to detach, reducing steering control and increasing crash risk. Key Details regarding the 2011 Mazda6 Subframe Recall: Scope: The recall affects specific 2011-2013 Mazda6 vehicles (and 2009-2010 models in a previous, related...

Read the full complaint

recall). Location Restrictions: Vehicles must have been originally sold in, or currently/previously registered in, 23 "salt belt" states (including CT, NY, MI, MN, OH, etc.). The Issue: The front cross member may experience severe corrosion, causing structural failure of the passenger-side lower control arm mounting point. Symptoms: Drivers may notice a change in steering alignment or a broken cross member. Remedy: Dealers will inspect the cross member and replace it if necessary. Action Required: Owners should contact their local Mazda dealership to check their VIN for open recalls. The recall was officially announced in May 2019 and is an expansion of a 2018 action.

Filed Incident Suspension · Unknown or otherNHTSA 11715942
2011 Mazda MAZDA6SteeringSuspensionBody, doors & structure

2011 Mazda6 A serious safety defect occurred on my vehicle and matches NHTSA Recall 19V-323 / Mazda Recall 2818I (front cross member corrosion due to insufficient coating) despite this recall not being associated with my VIN. Front cross member cracked due to rust, causing loss of steering control, wheel misalignment, and scraping from the front wheel. This is exactly the failure described in the recall (breakage of the cross member and reduced steering control, increasing the risk of a crash). My safety and the...

Read the full complaint

safety of others were put at risk. Although my VIN is not currently associated with the recall, all conditions of the recall apply to my vehicle: -2011 Mazda6 within the affected production range -Defect is a manufacturing issue (insufficient paint coating) -Vehicle was registered in Missouri from 2023-2025, which is a listed state The only reason this recall was not associated with my VIN is because the vehicle was not registered in Missouri at the exact time of the 2019 recall campaign. This is an administrative gap, not a safety distinction. It should not be allowed to limit a manufacturer safety defect to specific states. Vehicles move across state lines constantly. A defect that causes loss of steering control does not stop being dangerous when a car crosses a border. Registration records alone did not reflect actual vehicle use or risk. If recalls are state-limited, manufacturers and NHTSA must continue tracking registration changes and associate the recall with the VIN as soon as a vehicle becomes registered in an affected state. Rust is progressive and age-related. Since this recall began in 2019 and it is now 2026, affected vehicles are more likely to experience failure, and many are now registered in different states than they were in 2019. I am requesting that NHTSA associate Recall 19V-323 with my VIN, investigate the adequacy of state-limited recall tracking, and take action to prevent this known safety defect from causing additional crashes.

Filed Incident Steering · Suspension · StructureNHTSA 11713263
2012 Mazda MAZDA6Suspension

The rear subframe and suspension parts are rusted so bad that the car is not safe to drive. Looked up recalls and found out the front subframe had a recall and was taken care of before I bought the car. Also found recall for my model of car that were registered in state that use salt on there roads which is one of the state i live in. Was told my Mazda corporation the only certain 2012 mazda vehicle's vehicle's were covered for rusting issues with the rear . If the front of the car is recalled and the same problem...

Read the full complaint

happens with the rear of the car shouldn't it be covered for something? I have an appointment coming up on the 21 of January which is ridiculous that I have to wait 3 weeks to have it looked at. . Thank you for your time. The only reason I found the problem with the car was a stick got stuck in the rusted out parts and when I took it out a bunch of rust fell on the ground.

Filed Incident Suspension · Unknown or otherNHTSA 11710529
2011 Mazda MAZDA6Suspension

When I took the car into my ASE mechanic shop for a normal oil change and tire rotation, they performed a general overall car inspection. They noticed that the Driver Side Rear Subframe had rusted through completely, where the coil spring is located. The passenger side was rusted, but has not yet broke through. They stated that the subframe parts should not rust through like this. They also stated that it is dangerous to drive the car in this condition. I have not notified the manufacturer as of yet, but plan to do...

Read the full complaint

so. There were no warning lights, but the ride did seem to be rougher than normal. The attach photos contain 2 photos of the failed driver side rear subframe and 1 photo of the good, passenger side rear subframe.

Filed Incident Suspension · Unknown or otherNHTSA 11700788
2012 Mazda MAZDA6SuspensionBody, doors & structure

The contact owns a 2012 Mazda Mazda6. The contact stated while driving 55 MPH and crossing a bridge, the vehicle stopped unexpectedly after driving over several expansion joints. The contact stated that the vehicle had not stalled. The contact exited the vehicle and noticed that the passenger's side front wheel was slanted into the wheel well. The contact inspected the wheel well and noticed that the control arm had sheared off at the cross member. The contact stated that prior to the failure, the steering wheel...

Read the full complaint

had turned slightly to the right. The contact researched online and related the failure to NHTSA Campaign Number: 19V323000 (Structure, Suspension), which included the VIN. The contact stated that the vehicle was towed to a dealer, where the contact was advised that the VIN was included in a recall, and the contact was advised that the vehicle needed to be diagnosed to determine the cause of the failure. The contact stated that the dealer had not diagnosed vehicle in a month. The manufacturer was informed of the failure and advised the contact to work with the dealer. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer and dealer had exceeded a reasonable amount of time for the recall repair. The failure mileage was approximately 188,000.

Filed Incident Suspension · StructureNHTSA 11698215
2011 Mazda MAZDA6Suspension

2011 Mazda6 rear subframe rot/rust, unsafe and dangerous to drive, Same situation as the front subframe that is part of a recall.

Filed Incident SuspensionNHTSA 11695663
2009 Mazda MAZDA6Suspension

Component or System that Failed: The front subframe on my 2009 Mazda 6i Touring is completely rusted through. There are holes in the frame and large flakes of rusted metal breaking off. The car is available for inspection if needed. Safety Risk: This is a serious safety concern because if the subframe fails, I could lose steering or suspension control while driving. That would put me and other drivers at immediate risk of an accident. Reproduction / Confirmation: An independent mechanic confirmed the problem and...

Read the full complaint

told me the car is unsafe to drive in its current condition. Inspection: The vehicle had the original Mazda subframe corrosion recall performed years ago, but now the same exact problem has come back. The car has not yet been re-inspected by Mazda, but the severity of the rust is obvious. Warning Lamps / Symptoms: There were no warning lights or messages before this happened. The issue was only noticed when the rust and holes became visible on the underside of the car during a recent inspection.

Filed Incident SuspensionNHTSA 11683036

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience