The contact owns a 2017 Ram 3500. The contact stated that while driving approximately 40 MPH, the vehicle drove over a small pothole in the road and suddenly experienced the death wobble, causing the vehicle to violently shake and vibrate, which caused the weld on the track bar mount to separate from the frame of the vehicle. The vehicle was undrivable. A Police report was taken at the scene. The cause of the failure was not yet determined. The manufacturer was notified of the failure. The failure mileage was 206,000.
Suspension
Ram 3500 Suspension problems by year
122 complaints filed with NHTSA about the Ram 3500's suspension. Broken springs, struts, control arms, ball joints, noises and alignment that won't hold.
Suspension complaints by model year
Latest 3500 suspension complaints
I own a 2015 Ram 3500 equipped with the 6.7L Cummins diesel engine. An authorized Ram dealership diagnosed an engine oil leak originating from the timing gear housing-to-engine block/cylinder block gasket. The leak has progressed beyond minor seepage. Engine oil is traveling down onto the chassis/track bar area and is leaving drops on the ground. The dealer estimated the repair at approximately $4,000 because of the extensive labor required to access and reseal the timing gear housing. My concern is that an engine...
Read the full complaint
oil leak from this sealed housing may worsen over time and could potentially result in significant oil loss, contamination of nearby chassis components, or oil reaching hot engine/exhaust components depending on the path and severity of the leak. FCA/Stellantis has previously issued technical communications concerning oil leakage from the timing gear housing gasket. STAR Online Case [[redacted]], titled "Oil Leak From The Front Timing Gear Housing Gasket," instructed dealership technicians to document the leak location, photograph the condition, and measure the breakaway torque of the timing gear housing retaining bolts. FCA also issued later engineering communications involving the rear gear housing/timing case gasket on later Ram 6.7L diesel trucks, including requests to document loose housing bolts and retain removed bolts for engineering analysis. I am submitting this complaint because I believe this may represent a recurring engine oil leakage condition involving the timing gear housing on Ram heavy-duty trucks equipped with the 6.7L Cummins diesel engine. I am requesting that NHTSA review owner complaints and manufacturer technical communications to determine whether this condition presents a broader safety-related defect. Vehicle: 2015 Ram 3500 Laramie 4x4 Engine: 6.7L Cummins Turbo Diesel VIN: [[redacted]] Approximate repair estimate: $4,000 Dealer diagnosis: timing gear housing-to-engine block/cylinder block gasket oil leak INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
See attached document for complaint.
Pursuant to a manufacturer-issued safety recall (V06) on a steering assembly component, the manufacturer's remedy permanently damaged an otherwise functioning, adjustable steering component and created a financial barrier to basic vehicle maintenance. The component, post remedy, now would have to be replaced in order to allow adjustment to put the vehicle steering system into correct alignment. Driving a vehicle without proper front end alignment can cause premature tire wear contributing to tire failure and/or...
Read the full complaint
pulling to the right or left contributing to a possible accident condition. The manufacturer is refusing to pay for the replacement parts/repairs that, but for the recall remedy, would be necessary.
The truck is in for its second front end alignment. I bought it brand new in October 2024 and it has about 43000 miles on it. I'm concerned for my family's safety. If it is going out of alignment this often, I don't feel safe driving it. The dealership has no explanation of why its going out so fast. I know I'm not the only one having this problem. There are thousands of people saying they are having the same issues. It was out of alignment from the factory. Pretty much all of them are. Something needs to be done about this. I put today's date but the first time I took it in was less than a year and 20000 miles ago.
Front axle disconnect failed at only 15,136 miles
when towing the rear end bounce you in on coming lanes! I saw oil on shock took to dealer they fought me on replacing it then they said they will replace 1 and want to send me down the road 1/2 fixed ! No dealer will replace 1 always in pairs because it will cause un even braking and safety issues ! This was at Auburn jeep [[redacted]] ! If they do this type of work jeperdizing peoples safety they should have there licence pulled INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
There was a recall forced by the NTSB for a condition where the track bar adjustment nut would come loose and the truck would lose steering. The recall on the track bar was rectified by the dealer by welding the nut on the track bar. Now that the nut has been welded a proper alignment can not be preformed. There is no longer adjustment available due to the welded nut. The only way to properly fix this is to replace the track bar. I have had many communications with ram (stellantis) and they refuse to remedy this as they tell me they have complied with the NTSB's resolution.
Both front ball joints wore out at 20,000 miles The 3rd break light leaks into the cab at 26,000 miles & won't be warrantied even though there's an active recall for our same truck, same part just different model
V06 Recall was attempted, but welding could not be done correctly - was told that was the "best they could do" truck continued to steer poorly (constantly have to hold the steering wheel to one side or the truck will veer out of the lane) bc steer ahead wrong, and to wear outer edge of the tires to an unsafe level in less than half the normal mileage. Now Dodge dealership/Stellantis claims the drag link assembly was permanently damaged by their prior recall work, and that truck cannot be aligned or driven safely...
Read the full complaint
but also won't fix it. They have been telling me they will action the case "today" or "one businesses day" since 27 Aug. I found out that the alignment and steering problem I had been spending money to fix since 2019 was a result of their poor recall repair and trying to get a response from Dodge Stellantis since AUG 06, and I have been without the use of the truck and unable to care for my horses since then. I have spent more than 14 hours directly on the phone with them without any action - my truck remains essentially impounded at the dealership. Est 20k miles at initial recall V06 failed repair attempt but their records should say. Current document is currently dealership that admitted the initial recall repair attempt damaged the draglink assembly beyond any hope of salvage/alignment.
Steering and/or front suspension developed into what is called a death wobble at 70mph. The steering wheel had so much hard wobble that it became almost uncontrollable to hold onto it, and keep the vehicle moving straight which put the vehicle onto the shoulder and into a shallow ditch. Has the problem been reproduced or confirmed by a dealer or independent service center? No, but when it happened previously, I had it looked at, and supposedly repaired. Has the vehicle or component been inspected by the...
Read the full complaint
manufacturer, police, insurance representatives or others? No, there was no damage to the vehicle, but I am taking it back to the shop where the repair was supposedly made. Were there any warning lamps, messages or other symptoms of the problem prior to the failure, and when did they first appear? No, it came on suddenly.
Ton of warning lights can on like abs, traction control and some other sensors. When put in Drive the D flashed and try k would not move. Put back in park would not recognize it was in park and would not shut off. The only way to shut off the truck with disconnect both batteries and pull the fuse for the fuel pump.
We were traveling on a highway doing 70mph and the whole truck started to shake really badly. My husband could not steer the vehicle safely, nor could he brake without losing control. He had to slow down until the shaking stopped. When we got back on the road, the vehicle did the same thing three times. This is known issue with Dodge, yet they don't have a fix for it. They call it the "death rattle"
Break controller/traction control/cruise control all are not working an being a RV owner WE tow a 2014 Redwood 42 foot 5th wheel, 16000 max weight (our scaled is 14640 pounds). We do not feel that it is safe to tow our RV with the recall that affects towing. This is the 3rd recall/repair on this truck. Please advise us on the towing recommendation/safety on using our truck to tow our RV.
The contact owns a 2013 Ram 3500. The contact stated while driving 65-68 MPH over a bumpy road surface, the steering wheel and the front end of the vehicle shuddered significantly. The contact decelerated, exited the freeway, and pulled over to the shoulder of the road. The contact was able to continue driving. The vehicle was taken to the dealer, where the contact was informed that the vehicle had experienced the death wobble. The dealer diagnosed the vehicle and determined that the upper ball joints and control...
Read the full complaint
arms needed to be replaced. The dealer replaced the upper control arms. The vehicle was then taken to an independent mechanic, where the upper ball joints were replaced. The contact stated that the failure recurred several times while driving. The contact stated that the upper and lower ball joints, the control arms, the bushings, and other unknown parts were replaced several times; however, the failure persisted. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 100,000.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data