On certain motor homes built on workhorse chassis and equipped with general motors 8.1L v8 engines, improper hardening during the heat treatment process can cause the fuel rail pulse damper retainer clip to fracture, resulting in inadequate retention of the...
Updated daily from NHTSA
Latest vehicle recalls
38 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
On certain passenger vehicles, a combination of throttle positioning sensor irregularities, a dirty throttle housing, and/or inefficient software calibration may cause a warning lamp to light and the subsequent onset of limp home modes.
Certain passenger vehicles fail to conform to the requirements of federal motor vehicle safety standard no. 212, 'Windshield mounting.' The windshield may not be properly secured to the vehicle body.
On certain sport utility vehicles, the owner's manual does not contain the required higher rollover risk warning information.
On certain passenger vehicles, the hood latch striker may break and allow the hood to open while driving.
On certain class a motor homes, heat shields were not installed in the lp tank bay.
On certain conventional trucks equipped with the aisin automatic transmission, the parking brake cable and automatic transmission shifter cable may have been routed incorrectly. This mis-assembly could cause chafing of the parking brake cable and eventual...
On certain passenger vehicles, the fuel pump module and the power train control module (pcm) software may allow the engine to stall under certain operating conditions.
On certain transit buses built with cummins isl and isc diesel engines equipped with the cm850 fuel system, the engine high pressure fuel lines, from the engine high pressure pump to the engine fuel rail, are prone to failure.
On certain motor homes, an improper nut and bolt combination was used to clamp the intermediate shaft onto the steering shaft. Without the proper nut and bolt combination, the nut can loosen prematurely and allow the bolt to come out which could allow the...
On certain recreational vehicles built with dometic two-door refrigerators, a fatigue crack may develop in the boiler tube in the area of the weld between the boiler tube and the heater pocket. A fatigue crack may release a sufficient amount of pressurized...
Certain my 2004 through 2006 thomas built mvp-ef school buses manufactured between september 27, 2004, and september 10, 2006. The steering column floor seal forms a well around the column at the floor. Debris, such as loose fasteners, may get trapped in...
On certain trucks equipped with arvinmeritor front axle assemblies, the front spindle nut may be over-tightened causing preload on the front wheel bearings which may lead to premature bearing wear.
Certain airtex fuel pump modules, p/nos. E7089m, e7094m, e7113m, and e7129m, manufactured between june 1 and september 24, 2006. These fuel pump modules were sold as aftermarket for use in certain daimlerchrysler vehicles listed above. Silicone material...
On certain trailers equipped with dexter axles, the disc brake caliper mounting bolts may strip. Insufficient clamp load between caliper and yoke can cause the caliper to disassemble and adversely affect the trailers braking system.
On certain vehicles, the fuel tank is missing the adhesive layer that bonds the barrier layer to the outer shell of the fuel tank.
Some passenger vehicles may have fuel tanks in which the fuel delivery module (fdm), jet pump module (jpm), and/or cluster valve (cv) seals are not properly retained in the fuel tank. This may result in illumination of the malfunction indicator lamp (mil)...
Certain vehicles originally built with cloth seats that were equipped with an automatic air bag passenger sensing system and later reupholstered with aftermarket leather seat cover kits are involved. Testing has indicated that the aftermarket leather seat...
Certain 1998 through 2006 universe and sturdibus school buses manufactured between january 1998 and october 23, 2006. The label explaining crossview mirror use is not visible to the seated driver which fails to conform to federal motor vehicle safety...
On certain vehicles equipped with automatic transmissions, the key lock cable was improperly manufactured and may not allow the cable end to lock into the floor shifter mechanism. This can result in the interlock system to become inoperative and allow the...