On certain utility trailers equipped with rfd wheels, there is a defective weld of the wheels center hub to the wheel rim.
Updated daily from NHTSA
Latest vehicle recalls
38 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
On certain trucks, a leak in the aset ac fuel injection line may spray fuel on the exhaust gas recirculation pipes that carry hot exhaust gases .
On certain trucks equipped with chalmers rear suspensions, the adjustable torque rod end castings may be brittle. A brittle rod end casting may fracture without warning, causing the vehicles' rear axles to become misaligned.
On certain trucks equipped with arvinmeritor axle assemblies, the torque rod tower has a nonconforming location and weld. The weld can crack, leading to the tandem axle losing its anchor point, causing the driveline to bend to an angle outside its operating...
On certain motorcycles, the long pivot bolt may bend or break during normal operation of the motorcycle.
On certain trucks equipped with arvinmeritor rpl20 high angle interaxle driveshafts, an improper seated or missing snap ring can result in the bearing cup to separate from the slip yoke sub-assembly. The universal joint cross could then contact the slip yoke...
On certain vehicles, the right front steering knuckle may have been improperly manufactured. Because of a broken cooling line, parts cast in tool cavity #63 on july 18 and july 19, 2006, may have a cold shut condition and could fracture.
On certain trucks equipped with arvinmeritor rpl20 high angle interaxle driveshafts, an improper seated or missing snap ring can result in the bearing cup to separate from the slip yoke sub-assembly. The universal joint cross could then contact the slip yoke...
On certain trucks equipped with chalmers rear suspensions, the adjustable torque rod end castings may be brittle. A brittle rod end casting may fracture without warning, causing the vehicles' rear axles to become misaligned.
Certain trucks fail to conform to the requirements of federal motor vehicle safety standard no. 111, "Rear view mirrors". The right outside rear view mirror glass has a curved (convex) mirror glass installed instead of flat glass. Curved glass creates a...
On certain passenger vehicles currently registered in the following states: alaska, colorado, connecticut, delaware, idaho, illinois, indiana, iowa, kansas, kentucky, maine, maryland, massachusetts, michigan, minnesota, missouri, montana, nebraska, new...
On certain motor homes built on workhorse chassis and equipped with general motors 8.1L v8 engines, improper hardening during the heat treatment process can cause the fuel rail pulse damper retainer clip to fracture, resulting in inadequate retention of the...
Certain vehicles fail to conform to the requirements of federal motor vehicle safety standard no. 110, "Tire selection and rims." The label denoting the tire and loading pressure information is incorrect.
On certain motorcycles, the fuel pump and ignition relays installed during production could be defective. This can cause the instrument panel to stop functioning and the engine to stop.
On certain motorcycles, an improperly designed throttle position sensor could cause an intermittently unstable idle when the engine is at idling speed when the motorcycle is stopped or during low-speed operations. The engine could stall as a result.
On certain fifth wheel trailers, the hub weld is insufficient to hold the spindle to the axle tube.
On certain low speed vehicles, three bolts on the back of the power signal distribution module (psdm) may not have been tightened properly which could cause a total loss of power to the vehicle.
Certain my 2001 through 2006 mid bus guide school buses manufactured between january 1, 2002, and may 16, 2006, equipped with collins 3 passenger seats, freedman activity seats, or unistrut track seating with 2 passenger seats. The seats may not have had the...
On certain buses equipped with vapor bus connecting rods, when the connecting rod is subjected to certain load combinations and cumulative cycling, initiation and propagation of fatigue cracks are seen at the external thread roots. If the crack initiates and...
On certain trucks, the brake cam tubes on the steer and drive axles may not have been greased.