Certain boat trailers fail to conform to the requirements of federal motor vehicle safety standard no. 110, 'Tire selection and rims.' The original capacity tag displays an incorrect weight capacity for the trailer.
Updated daily from NHTSA
Latest vehicle recalls
38 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
On certain passenger vehicles equipped with adjustable brake pedals, the stop lamp switch wiring harness may be out of position. An improperly positioned stop lamp switch wiring harness could make contact with the u-joint assembly of the steering column...
Certain boat trailers fail to conform to the requirements of federal motor vehicle safety standard no. 110, 'Tire selection and rims.' The original capacity tag displays an incorrect weight capacity for the trailer.
Certain motor homes built on freightliner chassis may have been manufactured with tie rods that are too short for the front axle crossbar taper. The resulting gap between the crossbar and tie rod end may result in corrosion between the 2 pieces. Lack of...
On certain passenger and sport utility vehicles and pickup trucks equipped with automatic transmissions, the software programmed into the powertrain control module can cause a momentary lock up of the drive wheels if the vehicle is traveling over 40 mph and...
On certain sport utility vehicles equipped with front bench seats only, if fluid is spilled from the floor mounted cup holder, an unused console power outlet connector located under the seat may become contaminated.
Certain motor homes were not equipped with fuel fill ground cables.
On certain grain trailers, a fatigue failure (cracking) of the aluminum angle behind the king pin support beam can occur causing distortion of the bottom rail and compromising the king pin assembly.
On certain tandem-axle boat trailers equipped with 14 inch wheels, failure of the wheel to seat properly and securely on the wheel hub can occur. This can cause the lug nuts to become loose even after being tightened to the proper torque specifications.
On certain passenger vehicles, the metal forming part of the front crossmember may have been improperly stamped resulting in the metal becoming thinner in the cross-section than specified. This could, over time, result in breakage of the crossmember.
On certain fifth wheel trailers, a jumper wire between the two neutral bars is not of adequate gauge.
On certain motor homes, existing fasteners used to secure the satellite dome to the motor home roof do not penetrate the roof sufficiently to prevent the dome from coming off while the vehicle is in transit.
During a canadian compliance test, certain sport utility vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 108, 'Lamps, reflective devices, and associated equipment.' The headlamp assemblies do not meet the headlamp...
On certain passenger vehicles, the lower rubber mount of the rear shock absorbers may not have been manufactured to specifications and may not adhere correctly to its housing within the shock absorber.
On certain 2-door passenger vehicles, the rear windshield or rear quarter glass panels do not properly adhere to the body of the car due to improper window opening preparation.
On certain passenger vehicles, during production of the driver's frontal air bag, the air bag may not unfold properly in the event of a crash and therefore may not inflate as designed.
Certain trucks equipped with the tri-drive option fail to comply with the performance criteria requirements of federal motor vehicle safety standard no. 121, 'Air brake systems.'
Certain buses fail to comply with the requirements of federal motor vehicle safety standard no. 120, 'Tire selection and rims for motor vehicles other than passenger cars.' An incorrectly labeled weight sticker was attached.
On certain walk-in vans, the stop lamps may be intermittent during light brake applications. The cruise control may not immediately deactivate when the service brakes are applied.
On certain sport utility vehicles, the wall thickness of the right forward baffle of the fuel tank may be below specifications.