Certain medium duty trucks equipped with the allison series 2500 automatic transmission do not have a park position available inside the automatic transmission. These vehicles may have been assembled with an automatic transmission shift lever control...
Updated daily from NHTSA
Latest vehicle recalls
38 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
On certain transit buses equipped with ricon platform style wheelchair lifts, the wheelchair lift vertical support arms were improperly welded.
On certain trucks, an ra529 king pin release air valve was manufactured with the internal spool installed backwards. This results in the air option of the king pin release system being inoperable. To correct this situation, the vehicle's air lines were...
On certain king cab trucks, the wires in the harness were routed through the rear doors and into the body. These wires may break due to over bending of the harness as the door is opened and closed. The harness contains wires for the driver seat belt...
Certain fifth wheel trailers fail to comply with the requirements of part 567, "certification." The federal certification tag was printed with an incorrect tire value of 80 psi and the correct tire pressure value is 65 psi.
On certain vehicles where a weak battery exists, it is possible that a low voltage condition could cause the air bag control unit to improperly set a fault code. If this occurs, the passenger side frontal air bag will become deactivated. However, both the...
On certain travel and fifth wheel trailers, the fuel station may be installed in such a manner as to limit the amount of transverse and/or lateral support for the fuel tank.
On certain fifth wheel trailers equipped with a demco glide ride pin box, the welds on the pin box can break.
On certain folding camping and travel trailers, the hub weld is insufficient to hold the spindle to the axle tube.
On certain g4500 motor coaches, the tag axle swing arm can break away.
On certain class a motor homes, the windshield wiper motors are under-fused and the fuse may fail.
On certain motor homes equipped with front overhead televisions, incorrect fasteners were used to secure the television located in the front overhead area of the motor home.
On certain motor homes built on workhorse chassis and equipped with gm 8.1L v8 engines, improper hardening during the heat treatment process can cause the fuel rail pulse damper retainer clip to fracture, resulting in inadequate retention of the damper. If...
On certain trucks equipped with a trw tilt/telescoping steering column, the tilt locking mechanism on the steering column may disengage. This could prevent the steering column from locking in to predetermined positions.
An incorrect switch was installed in the cruise control system on certain model t300 trucks.
On certain sport utility vehicles, during static air bag deployment testing conducted by nhtsa using fifth percentile female dummies indicated if a small statured adult driver, not wearing a seat belt, is involved in a frontal or near frontal crash...
On certain motorcycles, a battery caddy bolt may loosen under normal riding conditions. Should this occur, the bolt can back out which allows the battery to shift position and then hold the battery in a position which may allow the battery terminals to...
Certain 2000-2006 u.S. Bus sturdibus school buses manufactured between may 1, 2000, and may 2, 2006. The barriers were not installed correctly which fails to conform to federal motor vehicle safety standard no. 222, School bus passenger seating and crash...
Certain honda accessory trailer hitches, p/n 08l92-stk-200, manufactured between june 26 and july 8, 2006, and sold as aftermarket equipment for use on 2007 model year acura rdx vehicles. The hitches may have been improperly welded during installation.
Certain motor homes fail to comply with the requirements of part 567, "certification." The federal certification tag figures related to the rear tire pressure tag of 60 psi are incorrect. The correct rear tire pressure rating is 80 psi.