Latest vehicle recalls

Certain anzo combination headlamp assemblies sold as replacement lamps for use on certain passenger vehicles. Some combination lamps are not equipped with amber side reflectors which fail to conform to federal motor vehicle safety standard no. 108, "Lamps...

Certain aftermarket brake hydraulic master cylinders sold as replacement brake cylinders for certain ford, daimlerchrysler, and jeep passenger vehicles. These brake cylinders were sold under the brand names of napa, raybestos, aimco, ac delco, carquest...

Certain trucks equipped with dual rear wheels fail to comply with the requirements of federal motor vehicle safety standard no. 108, "Lamps, reflective devices and associated equipment." The trucks may have been inadvertently manufactured without the roof...

Certain sport utility vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 206, "Door locks and door retention components." An incorrect right front door latch reinforcement plate may have been installed which may cause...

On certain buses equipped with seat belts, the t-nut which holds the seat leg to the floor track is missing machined bevels.

On certain class b motor homes built on chevrolet chassis, when the rear axle lift kit was installed, the u-bolt nuts were not tightened properly.

On certain vans equipped with the power liftgate option, the power liftgate motor automatically disengages after the liftgate is powered open.

On certain sport utility vehicles, the material used to manufacture the front disc brake calipers may be brittle due to improper metallurgy.

On certain vans and sport utility vehicles, the front windshield wiper motor armature shaft may break.

Certain pickup trucks have galvanized-braided-steel tailgate support cables used to support the tailgate in the full open (horizontal) position. Over time these cables can corrode and fracture when loads are applied to them.

Certain trailers fail to comply with the requirements of federal motor vehicle safety standard no. 223, "Rear impact guards." Proper rear impact guards were not installed on these trailers.

Certain light trucks fail to comply with the requirements of federal motor vehicle safety standard no. 206, "Door locks and door retention components." An arc weld is missing on some right side rear door upper latch assemblies.

On certain motorcycles, the handle bar clamp bolts were not sufficiently tightened.

On certain travel trailers built with the optional fuel station and equipped with a great plains fuel pump, the fuel pump can leak fuel.

On certain pickup trucks, the bead of the tire may be damaged due to improper assembly of the tires onto the wheels.

Certain hydraulic brake hoses, p/n 171.611.107B, sold as replacement equipment for 1975-1985 volkswagen (vw) rabbit; 1985-1992 vw golf; and 1980-1992 vw jetta passenger vehicles. Possible brake hose rupture could occur which fails to comply with the...

Certain conventional and fifth wheel travel trailers may have been equipped with improperly hardened axle wheel studs.

Certain blue bird my 2006 micro bird school buses fail to comply with the requirements of federal motor vehicle safety standard no. 301, "Fuel system integrity." The affected buses were produced with an 8 inch bumper rather than a 10 inch bumper.

On certain vehicles, the bolted connections on the suspension's double wishbones may come loose over time or under extreme loading.

On certain motor homes equipped with kwikee brand electric entry step built with a control unit manufactured by american technologies, may develop an electrical short during cold weather, allowing for the potential of the plastic case to ignite.