On certain transit buses, the spot welds which hold the wheelchair ramp hinge assembly together can fail allowing the ramp to separate, when deployed under load, from the bus frame.
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
Certain pickup trucks fail to comply with either the requirements of federal motor vehicle safety standard (fmvss) no. 105, 'Hydraulic and electric brake systems' or fmvss no. 135, 'Passenger car brake systems.' These vehicles were built with a software...
On certain sports/camper trailers equipped with furnaces, the furnace was improperly installed so that the exhaust vent discharged into the occupied space of the trailer and the heated air discharged outside of the trailer.
Certain zf trading north america aftermarket wheel bearing kits, lemfoerder p/n 1402301, sold for installation on 1992-2001 mercedes benz sl500 (r129) vehicles after april 1, 2005. The caliper mounting bolts used in the wheel bearing kit may be defective...
On certain vehicles, the instrument cluster is experiencing electrical malfunctions. The instrument cluster contains gauges and indicators that must be illuminated whenever the vehicle is in operation.
Certain girardin 2004 and 2005 mb iv school and commercial buses manufactured between july 6, 2004, and february 10, 2005, equipped with carrier compressor mount brackets, p/n 86-62400-00. This weld is used to mount the secondary compressor for the...
Certain aftermarket airtex electric fuel pumps installed for use as replacement equipment for certain 1997-2004 jeep wrangler; 1997-2001 jeep cherokee; 1997-2004 jeep grand cherokee; and 2000-2003 dodge dakota vehicles. The plastic electrical grommet...
Certain fabtech aftermarket replacement pitman arms, p/nos. Fts71000 and fts71001, installed for use on certain 2001-2006 gm c/k 2500 pick up trucks and sport utility vehicles. The pin located inside the pitman arm can shear off due to a reverse bending...
On certain trailers, the air ride suspension hanger weld may fail at the attachment point between the hanger and the subframe.
Certain sport utility vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 210, "Seat belt assembly anchorages." The anchor bolt for the rear, left-hand side seat belt buckle directly behind the driver's seat does not...
Covers2004 Lexus RX330
On certain camping trailers, the hydraulic brake line p-clamp was incorrectly installed. This may cause the metal brake line elbow between the brake hose and the backing plate to break while traveling down the road leading to the loss of braking capabilities.
On certain trucks equipped with d12d engines, the exhaust gas recirculation (egr) cooler inlet pipes or the pipes that connect the egr valves to the cooler may crack or break.
Certain vehicles equipped with v6 engines may have a condition where fuel is no longer supplied to the engine. This condition occurs without the illumination of the fuel level low indicator light or the warning chime.
On certain motorcycles, the kickstand spring may stretch and detach from the mounting bracket or the kickstand.
On certain sedans equipped with moonroofs, a reinforcement bar was incorrectly assembled so that the bar may contact the glass in the moonroof. When closing a door or upon severe road impact, it is possible that the moonroof glass may shatter.
Covers2006 Jaguar XJ
On certain vehicles produced from september 2002 - march 2003, equipped with 1.8L turbo, 2.8L v6, or 3.0L engines, a change in the electrical motor components in the fuel pump can lead to an inoperative fuel pump and, ultimately, stoppage of fuel supply to...
On certain motor homes, the wire harness may have been routed too close to the exhaust tail pipe which may result in the cable melting and creating an electrical short.
Covers2006 Jayco Escapade
On certain transit buses equipped with relay valves built by haldex/midland and distributed by meritor/wabco with valve body date code of 342a4k. This valve, which is installed in the rear axle air brake circuit, can fail resulting in a loss of air pressure...
Certain 2006 thomas built hdx school buses manufactured between july and november 2005. The front spring eyes may crack from embrittlement due to an improper heat treat process.
On certain california-specification model motorcycles, repeated stress from vibration can cause a crack to form in the area where the liquid/vapor separator bracket is welded inside the fuel tank. This can allow fuel leakage to occur.