On certain motor homes built on chevrolet 2500/3500 van chassis, while replacing the steel rims with aluminum rims, incorrect valve stems with incorrect pressure rating lower than the maximum pressure allowed for the tires were installed.
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
On certain buses equipped with compressed natural gas fuel containers, the thermal properties of the original exhaust blanket were insufficiently achieved with the component supplied. The performance of the exhaust temperature and the exhaust blanket were...
On certain buses equipped with compressed natural gas or diesel engines, the hydraulic cooling fan motor pipes can leak.
On certain passenger vehicles, the the radiator upper hose clamping is insufficient.
On certain heavy-duty class 8 vehicles, the automatic antilock brake system (abs) brake sensor bracket may not have been installed correctly on the front axle and may interfere with the brake shoe return spring. This could cause the brakes to not release or...
On certain trucks, the tie rod end ball joint dust boot was designed with insufficient sealing ability. This condition could allow contamination to enter into the tie rod end ball joint, abnormally wearing the resin bearing located inside the joint.
On certain passenger vehicles, the occupant position detection system's side sensor is not installed in the correct position and may fail to shut off the passenger's side impact airbag if the occupant is out-of-position.
Certain passenger vehicles were produced with one or both rear brake hydraulic lines that can come in contact with or be affected by heat from the left engine exhaust manifold and the left exhaust pipe. The brake fluid could reach elevated temperatures and...
On certain trucks, some of the huck bolts on the cab may not have been properly installed.
On certain sedans, the left and right rear outboard retractor and turning loop bolts on the seat belts may not have been properly tightened.
On certain mini vans, condensation from the instrument panel air conditioning ducts may drop through vent holes in the top of the radio and result in a short circuit that subsequently sends direct current to the rear speakers.
On certain motorcycles, the kickstand spring attaching stud may break off allowing the kickstand to deploy into the extended position.
On certain buses equipped with sure-lok wheelchair securement systems, the sprocket teeth of the retractor assembly is out of alignment.
On certain trucks, the fuel tank mounting strap was not welded to specifications and may fail. The fuel tank strap supports and fastens the steps for the operator and passenger to enter and exit the cab.
Certain passenger vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 124, 'Accelerator control systems.' In hot ambient conditions, the accelerator pedal arm may stick at the attachment to the bracket and not return to...
On certain sport utility vehicles, vibration and heat may cause the tail lamp/stop lamp bulb to loosen in its socket. If this occurs, the bulb may flicker and eventually become inoperative.
On certain passenger vehicles, the rear lamps that provide stop and turn signals and tail lamp functions stop working because of inadequate contact between the bulb and socket. In addition, if one bulbs were to become inoperative while the vehicle was...
On certain transit buses, a light gauge steel was used for the floor frame crossmember located in the floor sub-frame.
On certain passenger vehicles, the internal wiring harness of the outer door handles may accidentally short circuit and open the electrical switch of the door.
On motor homes built on ford e-series chassis, the air filter element material process resulted in an air filter paper element that can smolder or burn. This change in filter paper composition combined with the configuration of the air induction system, may...