On motorhome chassis built by workhorse and equipped with bosch brakes, the pads can drag on the rotor surface due to the pin sliding.
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
On certain passenger vehicles equipped with 2.8L, v6 5-valve engines, and automatic transmissions, while driving during extremely low ambient temperatures the throttle may freeze in an open position due to ice accumulating in the throttle body.
Certain passenger vehicles equipped with 4-wheel antilock braking system (abs), 2.4L high output turbocharged engine, and 5-speed manual transaxle, may exhibit inadequate clearance between the left front brake tube and the transaxle housing.
On certain sport utility vehicles, an incorrect weld nut was installed. Lack of this bolt could eventually cause the subframe to crack or become deformed.
On certain passenger vehicles, the electronic park brake module, which controls the application of the parking brake, may unintentionally apply the parking brake without any indication or warning to the driver.
On certain passenger vehicles equipped with lhd manual transmissions, the hand brake, which applies the parking brake, may not apply sufficient pressure to the brake pads to prevent the vehicle from moving if the manual transmission was left in the neutral...
On certain transit buses equipped with detroit diesel series 40 engines, the turbocharger can fail allowing lubricating oil to spill onto the engine.
On certain phantom and low floor transit buses equipped with cummins 8.3L and 8.9L isc and isl diesel engines, oil can leak into the engine compartment from a crack in the cup plug.
On certain heavy duty trucks,the lower tie rod arms on certain axles were not induction hardened as required by international's specification.
On certain trucks trucks equipped with an f040t front axle. The front wheel hub outer bearing lock nut may have been improperly tightened during assembly, and an insufficient amount of grease may have been applied to the outer bearing.
On certain trucks using an f060t or f070t front axle, the front wheel hub outer bearing lock nut may have been improperly tightened during assembly, and an insufficient amount of grease may have been applied to the outer bearing.
Certain 2000-2004 my mid bus school buses equipped with sure-lok wheelchair tie-down securement assemblies p/n 8625-13 for use on certain school and transit buses. The sprocket teeth of the retractor assembly may be out of alignment causing the load pawl not...
On certain minivans, the driver's air bag may become disabled due to a failure of the clockspring, which is located in the hub of the steering wheel.
On certain transit buses equipped with detroit diesel series 50 engines, the turbocharger can fail allowing lubricating oil to enter the exhaust system.
On certain fifth wheel trailers, a deficiency in the structural integrity of the main frame rails could cause the rails to crack and axles could shift, causing the fifth wheel to pull erratically.
On certain motor homes manufactured with optional aqua hot hydronic heaters, the exhaust termination for the heater was located under the bedroom slide out, when it should have been placed beyond the periphery of the vehicle.
On certain motorcycles and scooters, the rear brake shoe material could separate due to improper adhesive curing.
On certain 40' and 60' transit buses, the hydraulic system that provides power to the radiator cooling fan and power steering system is subject to becoming unstable.
On certain passenger and sport utility vehicles, the cover bolts for the engine oil control valve may not be sufficiently tightened, allowing oil to leak from around the cover gasket.
On certain motorcycles, a condition occurs that could allow pressure to build up in the fuel tank. On fuel injected vehicles, this condition could cause fuel to spray out unexpectedly when the fuel cap is removed. On carbureted vehicles, excessive fuel...