Certain fe school and commercial buses built with ce white driver seats with a pedestal style mount and manufactured between january 10, 1992 through february 24, 2004. These pedestals can develop cracks rendering the seat unstable.
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
Certain 2005 my international 3300, 4000, and ce school and transit buses manufactured between may 24 and august 17, 2004. The left turn signal light and indicator light on the instrument panel may not illuminate during hazard operation due to an incorrectly...
On certain motor homes built on a freightliner chassis with a 400-hp cummins engine, a sheet metal "tab" on a wire cover located behind the accelerator pedal has the potential to catch on the accelerator pedal.
Certain motorhomes do not have brake lights that illuminate considerably brighter than the running or turn signal lamps if all are on at the same time.
Covers2004 Fleetwood Bounder
On certain transit buses manufactured with detroit diesel series 50 engine, the turbocharger compressor wheel can break, resulting in shaft imbalance and lubricating oil passes into the exhaust system.
On certain passenger vehicles, a crack in the air bag crash zone sensor housing can allow water to enter the sensor, causing a short circuit and illuminating the air bag warning light.
Covers2004 Mazda MAZDA3
On certain motor homes, the spare tire carrier bracket can fatigue and lead to fracture.
Certain my 2001-2005 amtran/ic corporation ce, fe, and re school buses equipped with sure-lok wheelchair tie-down securement assemblies p/n 8625-13. The sprocket teeth of the retractor assembly may be out of alignment causing the load pawl not to fully seat...
On certain motor homes, a circuit breaker in the clearance light circuit does not protect the circuit from a too high amperage draw caused by a towed passenger vehicle.
On certain motor homes, liquid propane (lp) gas cook tops were installed using a flexible rubber hose that could burn or melt.
On certain truck chassis, the steering gear mounting bolts were made of inconsistent bolt material, which has led to bolt failures. This inconsistent bolt material condition could result in a failure of a steering gear mounting bolts. The steering gear is...
On certain trucks, when the steering wheel is being turned, the dust cover may twine with the steering shaft and could result in the steering wheel operation becoming heavy.
On certain passenger vehicles, when replace the fuel filler cap to the vehicle's fuel tank filler neck, it is possible to over-tighten the cap inducing a poor seal. In the event of a vehicle roll-over, it is possible for fuel to leak past the fuel filler...
Covers2004 Jaguar X-Type
On certain fifth wheel recreational vehicles, during the model year change, two positions in the vehicle identification number (vin) were not correctly changed to indicate a new model year. Therefore, the vin tag illustrates an incorrect vin number.
On certain buses equipped with sure-lok wheelchair securement systems, the sprocket teeth of the retractor assembly is out of alignment.
On certain trucks equipped with valeo wiper systems, the wiper motor may be susceptive to salt intrusion that could possibly lead to a condition where the connector overheats to a point where the connector could ignite.
Certain passenger vehicles have the possibility that the recess retains a rubber seal ring, which is located at the end of the cylinder body, and may be corroded due to an improper washing process.
Certain my 2004 sbfx-a and sd u.S. Bus school buses built on ford e-350 and e-450 chassis. The vacuum pump may become disengaged from the engine's drive mechanism causing loss of the vehicle's primary braking system.
On certain trailers, the wheel assembly hub spindle nut on each axle may have been installed without a "keeper." The purpose of the keeper is to lock the spindle nut in place and, thereby, secure the wheel to the axle.
Cetain eaton hydraulics motor manifold assemblies model mcd 7810, rev g, p/n 02-198616, part of motor manifold assembly 100at00002a produced between december 2002 and march 2004 and sold for use on north american bus industries (nabi) transit buses model...