On certain trucks, the brake pedal pushrod was not tightened properly during assembly.
Covers2004 Freightliner FLD
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
On certain vehicles, there is a defect in the interaxle driveline yokes. The bolt holes located on the earwork of the male shaft yokes were manufactured with an oversized minor thread diameter.
On certain vans built on ford e250/e350 chassis and equipped with sure-lok wheelchair securement systems, the sprocket teeth of the retractor assembly is out of alignment.
On certain passenger vehicles, the high pressure diesel pumps were produced with an improper fastener, which could allow diesel fuel to escape from the pump.
On certain sport utility vehicles, the accessory tow hitch attachment bolts may not have been tightened to the proper specification.
Covers2004 Nissan Xterra
Certain buses fail to comply with the requirements of federal motor vehicle safety standard no. 217, "Bus emergency exits and window retention and release." These buses lack the correct number and size of emergency exits.
Covers2004 Champion CTS
Hehr emergency exit windows, model nos 1401 and 1407, for use on certain dailmerchrysler commercial buses (orion)nc my 2002-2004 slf buses, do not meet the emergency exit release requirements as specified in federal motor vehicle safety standard no. 217, Bus...
On certain sport utility vehicles, the accelerator cable may prevent the throttle from returning to the idle position.
On certain passenger vehicles, the right and/or left rear seat belts may not lock properly due to missing retaining pins on the housing.
Covers2004 Mazda MAZDA6
On certain trucks, the power feed harness p92-1993 terminals were not properly crimped.
On certain sedans and convertible model vehicles, the right steering knuckle may have been damaged during the component manufacturing process.
On certain motorcycles, the main wire harness has a ground distribution connector that is incorrectly assembled. Some electrical circuits may overheat and short, including the fuel pump.
On certain motorcycles, the front brake hose can become trapped between the lower steering flange and the steering lock peg when the vehicle is cornering.
On certain sport utility vehicles built with a 5.7L, 4.7L, or 3.7L engine, the positive battery cable may contact the front suspension upper control arm mounting bracket.
Covers2004 Dodge Durango
On certain travel trailers, during production, the wiring was routed over the top of the gray holding tank on the backside in a location where the wiring could become pinched by the heat plenum framing.
On certain sport utility vehicles built with 3.0L v6 engines, the accelerator cable may prevent the throttle from returning to the idle position.
On certain motorcycles, an adapter in the rear brake line connects a rigid section to a flexible section. If the rigid section is not properly engaged in the adapter, it is possible for a leak to develop.
Covers2005 BMW R1200 GS
On certain passenger vehicles equipped with front seat heating systems, upon entering and exiting the vehicle, excessive contact with the side bolster that is contained in the seat's backrest may damage the heating mat located in this area. If such damage...
Certain police motorcycles were built with a defective wiring harness. The antilock brake system (abs ) is wired through the same fuse circuit as the abs malfunction warning light.
On certain trucks, the cable end of the parking brake cable, where it attaches to the parking brake lever, is designed improperly. Repeated normal parking brake operation may cause the cable end to become improperly seated in the parking brake lever groove.