Latest vehicle recalls

On certain trucks, a locking tab in the hood lock cylinder was improperly located preventing the cylinder lock from engaging. The hood lock cylinder is designed to support the hood once it is raised for access to the engine compartment.

Certain 2004-2005 sport utility vehicles and certain 2001-2003 sport utility vehicle having rear liftgate components serviced with 2004 equivalent components fail to comply with the requirements of federal motor vehicle safety standard no. 206, 'Door locks...

On certain trucks distributed by dodge or freightliner and equipped with a tire valve, tr600, on 16" tires, the valve can develop cracks within the rubber part or between the metal part and the rubber part of the valve stem.

Certain buses fail to conform to the requirements of federal motor vehicle safety standard no. 217, 'Bus emergency exits and window retention and release.' The operating instruction decals for the emergency latches may not have been placed on the emergency...

On certain motor homes, the water heater exhaust on the curve side wall under the back side of the kitchen slideout room box terminates under the slide box when in the extended position. This design could create a risk of migration of carbon monoxide into...

On certain motor homes built on a 20,700 gvwr or greater workhorse chassis, there may not be sufficient clearance in the area where the fuel line crosses the frame cross member.

On certain passenger vehicles, the upper and lower control arms may have casting imperfections at the end of each arm that may result in the arm fracturing.

On certain minivans equipped with second-row bucket seats or captain's chairs and a power sliding door on the passenger side of the vehicle, a passenger using the interior handle to open the power sliding door could be injured.

Certain michelin xde commercial truck tires, size 10r22.5 Lrg and lrf for use on freightliner school and transit buses. These tires were manfactured between may 23 and october 24, 2004, can experience rapid air loss due to an irregularity of the inner liner.

On certain sport utility vehicles and pickup trucks equipped with four-wheel drive (4x4), if moisture leaks into the front suspension upper ball joint, evacuation of the lubricant and corrosion of the joint may cause the joint to wear over an extended period...

Certain motor homes fail to comply with the requirements of federal motor vehicle safety standard no. 104, "Windshield wiping and washing system." While traveling at high speeds, the windshield wipers could either skip across the windshield or swing too far...

Certain fuel shut-off valves used as replacement equipment, p/nos 61338-02, 62169-02a, 61338-94d, and 62169-95c for use on certain 2005 carbureted sportsters, dyna, softail, and touring model motorcycles. These valves may have been produced with the...

Certain cut-away incomplete trucks equipped with lt225/75r16e tires fail to comply with the requirements of federal motor vehicle safety standard no. 120, 'Tire selection and rims for motor vehicles other than passenger cars.' The tire pressure is...

Certain 2004-2005 sport utility vehicles and certain 2001-2003 sport utiity vehicle having rear liftgate components serviced with 2004 equivalent components fail to comply with the requirements of federal motor vehicle safety standard no. 206, 'Door locks and...

On certain trucks, the air suspension height control valve may not be installed correctly.

Certain seat belt buckles on some motor homes fail to conform to the load requirement of federal motor vehicle safety standard no. 209, "Seat belt assemblies."

On certain passenger vehicles, the hazard switch and flasher system function may degrade over time because of distortion and material transfer of the contacts of certain hazard switch relays which occurs due to substantially increased electrical current load...

On certain passenger vehicles equipped with a front passenger power seat, when installing certain rear-facing infant child seat bases onto the seat with an excessively high seatbelt tension, it may be possible to unseat a component called the buckle status...

Certain passenger cars fail to comply with the requirements of federal motor vehicle safety standard no. 208, "Occupant crash protection." All three rear seat positions and the front passenger position are equipped with seat belt retractors that have a...

Certain passenger cars fail to comply with the requirements of federal motor vehicle safety standard no. 208, "Occupant crash protection." All three rear seat positions and the front passenger position are equipped with seat belt retractors that have a...