Latest vehicle recalls

Vehicle description: motor home chassis. These vehicles may have a mis-routed wire harness that attaches to the brake pedal position switch. The wire could rub on the steering column, resulting in a short circuit and a blown fuse, causing a loss of stop...

Vehicle description: motor homes, transit and school buses equipped with trw drag links. Each drag link assembly contains two 20-edl model ball socket assemblies. Certain of the ball-socket bearings have a below specification case depth and/or hardness...

Vehicle description: heavy duty trucks built with bendix air abs with an ec-17 1030r electronic control unit (ecu), there have been reports of unwanted abs activation at low speeds caused by 1) chafed abs wheel speed sensor wires on rotating parts or 2) a...

Vehicle description: passenger vehicles. One of two brackets used to bolt the front suspension control arm in front of the vehicle to the body structure may not have been welded sufficiently.

Vehicle description: school buses. These vehicles fail to comply with the requirements of fmvss 565, "vehicle identification number requirements." These vehicles were built with improper model codes.

Vehicle description: passenger vehicles. Through degradation of the bond between the silencer pad and a sheet metal panel (quarter inner upper), the pad may fall onto the map light located in the rear seating area near the c-pillar trim panel (lh and rh)...

Vehicle description: sport utility vehicles. The o-ring seals in the fuel line connector at the outlet end of the fuel filter were damaged when the line was connected to the filter during vehicle assembly. In some cases, this damage could result in a fuel...

Vehicle description: sport utility vehicles. The o-ring seals in the fuel line connector at the outlet end of the fuel filter were damaged when the line was connected to the filter during vehicle assembly. In some cases, this damage could result in a fuel...

Vehicle description: motorcycles. An improper service procedure that may be used during routine maintenance can damage a pressurized fuel hose. Lifting the front of the fuel tank beyond a certain point can stress and damage the hose. The internally damaged...

Vehicle description: transit buses. The front axle's spring tower bolts may not have been adequately tightened.

Vehicle description: certain transit buses equipped with abs fail to comply with the requirements of fmvss no. 121, "Air brake systems." The rear brake release time can exceed the requirements.

Vehicle description: certain transit buses fail to comply with fmvss no. 121, "Air brake systems." The rear brake release time can exceed the requirements.

Vehicle description: class a motor homes equipped with safety belt assemblies built by am-safe. On some seat belts, the buckle and connector may unlatch during a collision.

Vehicle description: motorcycles with half-fairing. The oil hose could fail on these motorcycles, causing the oil to spill under the rear wheel.

Vehicle description: class a and c motor homes equipped with safety belt assemblies built by am-safe. On some seat belts, the buckle and connector may unlatch during a collision.

Vehicle description: motorcycles. A rear wheel sprocket can break.

Certain passenger vehicles, limousines, and mini vans were built with a newly designed restraint control module (rcm). In some cases, the rcm does not recognize certain system faults that could result in an air bag or seat belt pre-tensioner unexpectedly...

Vehicle description: mini vans built with 3.3L and 3.8L engines have fuel rails with nitrole rubber o-ring seals that can degrade over time. Fuel leakage from the underhood fuel injection fuel rail could result, increasing the likelihood of a vehicle fire.

Vehicle description: heavy duty trucks equipped with trw tie rod ends on certain meritor axles. The tie rod and drag link ball stud ends contain bearings that are below the specified case depth and/or hardness.

Vehicle description: heavy duty trucks built with bendix air abs with an ec-17 1030r electronic control unit (ecu), there have been reports of unwanted abs activation at low speeds caused by 1) chafed abs wheel speed sensor wires on rotating parts or 2) a...