Latest vehicle recalls

Vehicle description: school and transit buses equipped with compressed natural gas engines (cng). The original pressure relief devices may vent unexpectedly.

Vehicle description: certain passenger vehicles, equipped with automatic transaxles, fail to comply with the requirements of fmvss no. 114, "Theft protection." These vehicles were built with an improperly adjusted automatic transaxle park lock cable...

Vehicle description: certain passenger vehicles fail to comply with the requirements of fmvss no. 301, "Fuel system integrity." These vehicles were built with an inadequate vent valve weld on the top portion of the fuel tank.

Vehicle description: quad cab pickup trucks. The upper control arms attached with cadmium coated nuts can cause the bolts to stretch due to the application of a higher than specified clamp load. Breakage of the upper control arm fasteners could cause the...

Vehicle description: passenger vehicles. Passenger air bags were built with suspect aluminum extrusion sections which may not retain the air bag door during an air bag deployment event.

Vehicle description: mini vans equipped with 2-spoke luxury wheels manufactured july 1992 through june 1993; or equipped with 4-spoke sport wheels manufactured from july 1992 through september 1993. The steering wheel armature stamping can crack and...

Vehicle description: passenger vehicles. The rear wheel hub retaining nuts can loosen and allow the left rear wheel and brake drum assembly to separate from the vehicle.

Vehicle description: passenger vehicles equipped with speed control and automatic transmission. A speed control cable could have a core wire that is long enough to catch on the sleeve at the throttle body end of the cable during wide-open throttle...

Vehicle description: on certain motorcycles, the spring in the cam chain tension adjuster can break. Excessive slack will develop in the cam chain, allowing the chain to jump to the wrong position on the cam shaft sprockets.

Vehicle description: passenger vehicles. The plastic ignition switch housing can fracture at the return spring anchor point. Fracture of the housing could cause the return spring force to be insufficient for returning the ignition key to the running...

Vehicle description: motorcycles. A fuel leak could occur from the fuel lever sender located inside the fuel tank.

Vehicle description: class a motor homes produced on roadmaster chassis. A 12vdc 50 amp mini-breaker on the refrigerator supply wire rather than a 12 vdc 30 amp breaker.

Vehicle description: boat trailers. The spindle is welded to the brake flange, which is welded to the axle assembly. If the weld is not deep enough, the weld could fail.

Vehicle description: heavy duty trucks equipped with trw 20-edl ball-socket assemblies. Certain of the ball-socket bearings have a below specification case depth and/or hardness which can lead to premature wear out of the socket. These bearings were...

Vehicle description: mini vans. One or more of the five bolts that mount the rack and pinion steering gear to the vehicle may have been incorrectly tightened.

Vehicle description: front and rear engine motor homes built on ford, spartan and workhorse chassis. All front engine class a motor homes built on ford and workhorse chassis were manufactured from january 1, through august 31, 2000. All rear engine motor...

Vehicle description: passenger vehicles equipped with a particular factory installed audio unit. If the vehicle is operated at low speed in a hot and humid environment with the window open, air conditioner running, and audio on, condensed water on the a/c...

Vehicle description: sport utility vehicles. During the manufacture of certain fuel return hoses, incorrect rubber material for the outer layer was used.

Vehicle description: certain crew vans failed to comply with the requirements of fmvss 225, "child restraint anchorage systems." These vehicles, which are designated as trucks, are 5 passenger vehicles with three designated seating positions in the second...

Vehicle description: heavy duty trucks. A support clamp was omitted from the front axle hydraulic brake line from the chassis to the brake.