Latest vehicle recalls

Vehicle description: motor homes produced on ford chassis. As a result of incorrect installation of the gas tank, the gas fill door for filling the gas tank is located within three feet of the water heater. This is in violation of rvia code, section...

Vehicle description: medium duty tandem rear axle trucks with abs. These vehicles fail to comply with fmvss no. 121, "Air brake systems." The air brake system was plumbed so that complete air reservoir isolation was not provided. Some vehicles were built...

Vehicle description: class b motor homes built on chevrolet g-cut away van chassis equipped with an after-market gasoline tank manufactured by transfer flow inc. Of california. The tank incorporates a rollover valve and a 5/8" rubber vent hose extending...

Vehicle description: motor coaches produced on roadmaster chassis and diesel class a motor coaches produced on freightliner chassis. The federal certification label contains the incorrect tire pressure inflation information. This does not comply with...

Vehicle description: motor homes equipped with dana ifs suspensions. One of the four studs used to attach the spindle to the front suspension wishbones has broken.

Vehicle description: trailers. The generator exhaust opening is under the trailer instead of being vented out the side of the trailer.

Vehicle description: passenger vehicles. The supplemental restraint system side air bag satellite sensors installed were improperly manufactured, causing the air bag warning light to illuminate and the side air bags to not deploy as intended in the event of...

Vehicle description: certain motor homes fail to comply with requirements of fmvss no. 120, "Tire selection and rims for motor vehicles other than passenger cars." These vehicles were assigned an inadequate gross vehicle weight rating (gvwr). Therefore...

Vehicle description: certain motor homes fail to comply with requirements of fmvss no. 121, "Air brake systems." The rear brake chambers installed on these vehicles as part of the air brake system are inadequate. The inadequate rear brake chambers could...

Vehicle description: certain motor homes fail to comply with requirements of fmvss no. 120, "Tire selection and rims for motor vehicles other than passenger cars." These motor homes have an inadequate front axle weight rating (fawr). They were built with...

Vehicle description: certain sport utility vehicles fail to comply with the requirements of part 567.4, "Certification." These vehicles were shipped from the assembly plant without safety certification labels.

Vehicle description: sport utility vehicles. The cast alloy throttle body is heated by fluid bled from the cooling system, to prevent icing in extremely cold weather conditions. This fluid passes through a small attachment (plate) to the throttle body...

Vehicle description: sport utility vehicles. Coolant system leaks have been identified in areas where the coolant could be subjected to elevated temperatures.

Vehicle description: certain sport utility vehicles fail to comply with requirements of fmvss no. 225, "Child restraint anchorage systems." The owner's manuals do not indicate which seating positions are equipped with child restraint anchorages. Also, the...

Vehicle description: class a motor homes equipped with safety belt assemblies built by am-safe. On some seat belts, the buckle and connector may unlatch during a collision.

Vehicle description: school and heavy duty trucks equipped with trw drag links. Each drag link assembly contains two 20-edl model ball socket assemblies. Certain of the ball-socket bearings have a below specification case depth and/or hardness which can...

Vehicle description: sport utility vehicles. The loading conditions on the vehicle's left side engine idler pulley can exceed the maximum calculated figure of the original design specification. The material of the pulley can fracture and ultimately fail...

Vehicle description: boat trailers equipped with 14" and 15" unique pro wheel and lug nuts. Due to paint on the wheel hub, the lug nuts were not tightened properly. The wheels could loosen during travel resulting in the wheel stud breaking. The wheel...

Vehicle description: class a motor homes equipped with safety belt assemblies built by am-safe. On some seat belts, the buckle and connector may unlatch during a collision.

Vehicle description: motor homes equipped with allison 1000 or 2400 series transmissions. These transmissions can experience park pawl to rear cover interference due to an out of flatness condition.