Latest vehicle recalls

Vehicle description: 6-7 car trailers. The right and left front corner lights and rear lights are too low.

These vehicles have dual axle steering with a hydraulic valve which diverts power assist from one side to the other as necessary. The hydraulic valve can be contaminated causing the valve to malfunction.

Vehicle description: heavy duty trucks. The throttle cable can bind due to misalignment with the fuel pump assembly.

Vehicle description: passenger vehicles. The seat belt retractor may have a pin shaft in the switchable elr/alr mechanism that is incorrectly formed. In some circumstances, the switching mechanism could become nonfunctional, preventing the seat belt...

Vehicle description: motorcycles. The rear belt drive pulley on these motorcycles may be defective. The pulley could separate.

Vehicle description: school buses. Some heater/defroster units were built with the blower motor wired improperly. When wired improperly the blower motor runs backward and airflow for heating and defrosting is very limited. This does not meet the...

Vehicle description: school buses equipped with anchor seats. Some of the seats were built with a seat mounting bolt that failed during testing. This does not meet the requirements of fmvss no. 210, "Seat belt assembly anchorages."

Vehicle description: passenger vehicles. Some of these vehicles do not comply with the head injury criterion requirements of fmvss no. 201, "Occupant protection in interior impact." The upper retainer clip near the bp1 impact location is designed to break...

Vehicle description: sedan l model passenger vehicles. Anti-rust coating was incorrectly applied to the transverse link mounting surface of the vehicle body. Over time the coating shrinks, causing a torque decrease of the bolt that secures the transverse...

Vehicle description: passenger vehicles. The brake system on these vehicles does not comply with fmvss no. 105, "Hydraulic brake systems."

Vehicle description: passenger vehicles. The right rear brake tube can contact the exhaust system clamp and wear a hole in it.

The 5th wheel trailer frame rails are fabricated from I beams. The web of these beams can crack above the axle attachments.

Vehicle description: passenger vehicles. The tie rods of the steering assembly are protected on each side by a seal to prevent moisture and dust particles from entering the swivel bearing mechanism. It is possible that some tie rod seals may not seal...

Vehicle description: passenger vehicles. The fuel filler pipe vent hose may have less than the intended level of ozone resistance, which could result in the hose becoming brittle and cracking.

Vehicle description: passsenger vehicles. Failures of the "easy entry" cable in the front driver or passenger manual seats can cause the seat fore/aft adjustable mechanism to be unlocked.

Vehicle description: passenger vehicles. The air bag sensor wiring pigtail insulation can become brittle and crack over time due to accumulation of water in the pigtail protective convolute in combination with high underhood temperatures related to the...

Vehicle description: transit buses. Failure of a soft seat check valve in wheelchair lifts provided by lift-u, may allow the front and rear platform barriers to return to a horizontal position from the vertical position they are supposed to be locked in.

Vehicle description: school buses built on chevrolet chassis with a corrugated steel floor and and equipped with 45" wide restraining passenger seats. The 45" wide restraining passenger seat fails to comply with the performance requirements of fmvss no...

Vehicle description: mini vans. The bolts used to attach the strut to the body and the rear liftgate can accumulate fatigue damage if three factors combine. If the bolt is loose, the gas strut is over-pressurized, and the frequency of opening and closing...

Vehicle description: dual steer class 8 heavy duty trucks. The front steer axle brakes do not comply with the requirements of fmvss no. 121, "Air brake systems."