Latest vehicle recalls

Vehicle description: mini vans. Heat generation in the wiring harness to the fuel pump/sender assembly can cause an electrical short. The vehicle could experience a loss of power and become immobilized and the fuel gauge may be erratic.

Vehicle description: sport utility vehicles. The coupling that connects the steering column shaft to the intermediate steering shaft is cracked. This could allow the steering shafts to separate.

Vehicle description: heavy duty trucks. The hook on the throttle return springs can fracture at low mileage.

Vehicle description: pickup trucks, crew cabs, utility trucks and sport utility vehicles. These vehicles were built with the polarity of the wiring for the zero adjust brake switch reversed from what was specified on the switch drawing. With the reversed...

Vehicle description: van and wagon model passenger vehicles. If water/road salt gets on the interior floor of the vehicle in the proximity of the air bag electronic control module (aecm), the aecm can corrode. The resulting corrosion can cause the driver...

Vehicle description: passenger vehicles. The sound absorbing mat attached to the inside of the b-pillar side trim panel could have been improperly installed. Surface and edges of the mat could have been damaged during the assembly process. It could ignite...

Vehicle description: school buses equipped with 30-inch and 34-inch seats and barriers or 36, 39, and 45-inch seats and barriers with offset legs installed in the first body section behind the driver. When narrow seats and barriers (30" and 34") or seats...

Vehicle description: medium duty trucks. A small seal boot in the self-adjusting brake system located on the right rear slack adjuster may have been torn in the movement of the vehicle during the assembly process.

Vehicle description: school buses mounted on navistar chassis. The standard cross view mirror assemblies installed on these buses do not conform to the requirements of fmvss no. 111, "Rearview mirrors."

Vehicle description: class a motor homes. These motor homes, when fully equipped and loaded with typical cargo, will experience an overloaded condition on the rear axle.

Vehicle description: class 8 heavy duty truck chassis equipped with mack 16,000 lb., 18,000 Lb., Or 20,000 lb. Heavy duty steering axles. The inner wheel bearing cone for the steering axle wheel hub assembly does not properly fit onto the mack steering axle...

Vehicle description: trailers manufactured by various builders for straightline manufacturing. The axles and axle components can bend and even break on some units allowing the axle to strike the frame causing damage to the axle and axle assemblies.

Vehicle description: passenger vehicles equipped with the optional traction control system. Due to improper design of the rear brake tube distribution, if one of the dual brake lines fails when the driver applies the brake, the vehicle will feel unstable...

Vehicle description: passenger vehicles. The headlights and taillights may not automatically illuminate in low ambient light when the headlight switch is placed in the "auto" position.

Vehicle description: fire trucks. The cab tilt system contains a 12 volt electrical solenoid assembly as an accessory to the cab tilt electric motor/hydraulic pump assembly. Rain, snow, salt spray or other corrosive environment can corrode the solenoid or...

Vehicle description: mini vans equipped with integrated dual child seats. Some of these vehicles may be missing a seat belt retractor clutch spring and/or pawl spring in the child seat. If the clutch spring was missing, the seat belt would lock in the...

Vehicle description: sport utility vehicles. As a result of water ingress and subsequent ice blockage, the transmission breather tube can become clogged, expelling transmission fluid from the dipstick tube onto hot engine components.

Vehicle description: motorcycles. The engine cam bolt can lose its clamp load and/or break.

Vehicle description: vans and vans used for conversion. If a heavy object impacts the metal casing of the air bag electronic control module (aecm), located under the driver seat, the module could inadvertently deploy the air bags.

Vehicle description: passenger vehicles. The rear suspension crossmember may be missing spot welds.