Latest vehicle recalls

Vehicle description: sport utility vehicles. The fuel line assemblies may have been damaged by the supplier during manufacturing, allowing leakage.

Vehicle description: motor homes built with kitchen slide-outs. A flexible liquid propane (lp) gas line within the slide-out can leak under certain conditions; e.G., When exposed to heat for prolonged periods of time from the stove.

Vehicle description: school buses built on a navistar chassis. The cross view mirrors do not comply with the requirements of fmvss no. 111, "Rearview mirrors." The entire top surface of cylinder h is not visible as required.

Vehicle description: passenger vehicles. These vehicles were produced or serviced with a horn assembly which could fail. The horn could either become inoperable or activate without the driver pressing the horn button.

Vehicle description: trailers equipped with aftermarket aluminum dual wheels, 22.5X8.25, One-piece, tubeless, supplied by accuride/akw. Certain design revisions combined with process conditions caused fatigue cracks in these wheels.

The center rear seat belt anchor plate exhibits stress cracks.

Vehicle description: 3 and 4-door passenger sedans. The steering wheel center bushing connecting the steering wheel hub to the steering column can slip.

Vehicle description: light duty trucks. The cast tow hooks changes the crash pulse of the vehicle in frontal barrier impacts and the air bag sensor was not calibrated to this new crash pulse which may cause the air bags to deploy in lower speed impacts than...

Vehicle description: motorcycles. Certain fuel pump/filter hoses and the fuel tank return hose can fail, resulting in a fuel leak.

Vehicle description: school buses. The emergency door hinges that consist of steel pin fittings and/or lacklubrication can bind from rust and/or corrosion.

Vehicle description: passsenger vehicles. Inadvertent deployment of the air bag can occur.

Vehicle description: transit coaches equipped with cummins l-10 engines and nelson catalysts and sold to los angeles, california transit authority. The catalyst can experience high temperatures, which could be caused from unburned methane igniting inside...

Vehicle description: transit buses. The tether plates, which are attached to the rear of both the upper and lower frames of the suspension unit, contain a sharp edge which can cause premature weat of the nylon tethers. This does not comply with the...

Vehicle description: heavy duty trucks equipped with a fal 8.0 Front steer axle. The upper steering arm can fail without warning.

Vehicle description: sport utility vehicles. These vehicles may have a missing or partially installed retainer clip that holds the master cylinder push rod to the brake pedal arm.

Vehicle description: passenger vehicles equipped with vr6 engines. A coolant system component such as the thermo switch, radiator fan, or water pump, can malfunction causing the coolant temperature and coolant system pressure to increase significantly...

Vehicle description: heavy duty trucks equipped with t444e diesel engines. A fuel leak can occur because of overcrimping of the hose end fittings on the hose from the regulator to the left head and the hose from the fuel transfer pump to the regulator.

Vehicle description: heavy duty trucks equipped with spicer spl170 55mm center bering package. The end yoke retaining nut can loosen.

Vehicle description: heavy duty trucks equipped with a t444e diesel engine. The high pressure oilline for the fuel injection system that goes from the high pressure oil pump to the right cylinder head can chafe against the charge air cooler crossover pipe.

Vehicle description: passenger vehicles equpped with the "california" emissions package. An incorrect transmission oil cooler line was installed. The line contacts the anti-lock braking system module support bracket and over time, can wear and develop a...