Latest vehicle recalls

The affected vehicles were built with outer tie rod ends with incorrect taper ball studs. The incorrect tapered ball studs can fracture within 50,000 miles.

Air system blockage in the air dryer occurs degrading the moisture removing capabilities of the dryer when the vehicle is operated in a cold environment and moisture accumulates and freezes in the air dryer or in the line between the dryer and the air system...

Improper installation of the rear brake line at the point at which the extended brake line first bends and extends over the left rear wheel area of the frame. If not installed with sufficient clearance, chafing of the brake line can occur in an area adjacent...

These wheels are composed of 2 pieces - a disc and a rim which are normally welded together. These wheels lack the specified fillet welds.

These seats may have an improperly located weld on a lever arm which supports the seat back. This weld can fail causing the seat back to fall backward freely without support to the driver.

The front safety belt buckle release buttons can break. These red plastic release buttons are marked "press." If a button breaks, pieces can fall into the buckle assembly causing the buckle to operate improperly.

These vehicles were assembled with a transmission reverse signal switch that could leak causing loss of electrical contact when the transmission is in reverse. This does not meet the requirements of fmvss no. 108, "Lamps, reflective devices, and associated...

Air system blockage in the air dryer occurs degrading the moisture removing capabilities of the dryer when the vehicle is operated in a cold environment and moisture accumulates and freezes in the air dryer or in the line between the dryer and the air system...

These wheels are composed of 2 pieces - a disc and a rim which are normally welded together. These wheels lack the specified fillet welds.

Air system blockage in the air dryer occurs degrading the moisture removing capabilities of the dryer when the vehicle is operated in a cold environment and moisture accumulates and freezes in the air dryer or in the line between the dryer and the air system...

The sensor's plastic case material can leak allowing the sensor to shut off the engine unexpectedly during abrupt turns or when riding over bumpy surfaces.

The wire end of the hand throttle cable passes through a split plastic grommet in the accelerator rod. This wire can work through the slot in the grommet and become lodged between the grommet and the edge of the hole in the accelerator rod.

The front safety belt buckle release buttons can break. These red plastic release buttons are marked "press." If a button breaks, pieces can fall into the buckle assembly causing the buckle to operate improperly.

Air system blockage in the air dryer occurs degrading the moisture removing capabilities of the dryer when the vehicle is operated in a cold environment and moisture accumulates and freezes in the air dryer or in the line between the dryer and the air system...

An inner wheel bearing cone may be missing on some of these trailers.

During assembly, the tie rod end nuts were not properly torqued. Extremely low torque can allow movement between the ball stud and the tie rod arm causing damage.

Two latches mounted on each side of the rear engine access cover and secure the cover when the motorhome is in transit were not positioned correctly.

The webbed belt retractors used to secure a wheel chair in the bus fail when the plastic retractor cover separates allowing the cover to open. This can allow the internal retractor spring to release out of the retractor.

A flexible brake hose that connects the hydraulic pump to the anti-lock brake system (abs) valve block assembly can leak causing loss of brake fluid.

Passengers' clothing can unknowingly become caught in the handrails at bus doors when exiting the bus.