The fuel hose to the fuel filter is routed too close to the alternator belt causing the alternator belt to rub the fuel hose. This can cause a fuel leak.
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
Improper material was used in manufacturing the radiator fan motor shaft causing the shaft to wear and become noisy.
These vehicles were assembled with rear outboard safety belt anchorages that may not withstand the required load. This does not comply with fmvss no.210, "Seat belt assembly anchorages."
The driveline could have little torque or no torque on the driveline nut that retains the yoke at the center bearing or bearings if the vehicle is equipped with multiple center bearings.
These vehicles were assembled with the left-hand lower control arm-to-frame rear nut not tightened to the specified torque.
The parking brake handle release button can separate from the parking brake handle assembly, causing the parking brake to be inoperative.
The routing of the positive battery cable can allow heat from the air discharge line to melt the cable.
Some temperature sensitive triggers were not x-rayed. These triggers could contain internal voids that would make the triggers susceptible to advanced creep causing false activation and venting of the cng.
The chassis harness is not properly secured to the frame of the trailer or is improperly routed over the axle.
The federal certification label incorrectly states the gross axle weight rating (gawr) causing the load ratings for the tires and tire pressures to be wrong. This does not comply with fmvss no. 120, "Tire selection and rims for motor vehicles other than...
The hydraulic lift cylinders are attached to brackets that are welded to the liftgate. The bracket welds can fracture.
The hydraulic lift cylinders are attached to brackets that are welded to the liftgate. The bracket welds can fracture.
One or both of the rear suspension lower spring seats are not securely attached to the shock absorber and can slide lower onto the shock absorber than intended. The rear spring would no longer function to support the vehicle body at its normal height.
Covers1995 Hyundai Sonata
The tires/tire pressures and wheels listed on the label are incorrect. This does not comply with fmvss no. 120, "Tire selection and rims for motor vehicles other than passenger cars."
Under high ambient temperatures (greater than 95 degrees fahrenheit) and the fuel tank level between 1/4 and 1/2 full, the fuel tank internal pressure can increase causing the tank to expand. Tank expansion causes an interference between the fuel tank...
Covers1995 AM General Hummer
When installed in the vehicles, a tie wrap is used to guide the cruise control cable in the engine compartment. Some tie wraps have been installed with a large loop opening improperly guiding the cable which could prevent the throttle from returning to its...
Both front seat belt lower anchorage rails have a manufacturing weakness which could fracture in a vehicle impact.
An incorrectly positioned wire within the electrically operated gearbox actuator can chafe against the cover causing the transmission selector fuse to blow.
The storage compartment at the rear of the unit does not have a specified storage weight limitation and can therefore be loaded beyond the manufacturer's intentions. Also some units were designed with a fresh water tank located at the rear of the unit. As a...
The fairing mount assembly bracket can crack and detach from the frame.