Latest vehicle recalls

Front axle assemblies may contain cracked brake drums due to improper fit between the wheel hubs and the brake drums.

The nato slave receptacle may be incorrectly installed with an insufficient clearance between the positive and negative shell.

The center safety belt attachment hardware brackets for the third seat may not withstand the specified tensile load.

Vehicles may have discrepant welds in the left rear rocker panel which can cause deformation of the panel.

The adjustable seat back structure and tilt mechanism may not withstand rearward force required by fmvss 207.

The routing of the throttle kickdown cable could allow chafing to occur between the cable and any one of three steel brake fluid lines near the valve block of the hydraulic brake unit.

The clamp load may not fully engage on the mating steering box splines due to manufacturing tolerances and/or the pinch bolt may not be properly torqued.

Tire information labels on the door and the information in the owners manual do not apply to the full size original equipment tire and wheel that was substituted for the "space-saver" emergency use only spare tire.

A fatigue crack in the rear brake line assembly could develop.

Positive battery cable lead to the starter solenoid may separate from the routing clamp cutting the insulation on the lead.

An incorrect bolt and nut arrangement and size was used to install both front and rear drive drive shaft assemblies at the differential pinion flanges.

Fuel pumps may have a loose rack fastener that could allow the bolt to come out of the rack.

Internal components of the e-12 dual circuit air brake valves may be misassembled so that one of the tapered snap rings is upside down.

Occupant release of the lap belt in a certain manner could cause the belt retractor to lock at the retracted and stowed position.

The air lines to the right rear brake chamber can be pinched by the auxiliary heater cabinet if the air in the rear air suspension system bleeds out when a leak develops or the engine has not been run for an extended period of time.

Special primer that promotes the bonding of a urethane adhesive to the glass was not applied to the windshields before installation.

An incorrect transistor may cause autolamp system light sensor module malfunction.

The forward outboard pedestal of the seat track of driver's seat may be susceptible to fatigue fracture.

Floor anchorage insert bolts for securing wheelchair are subject to break.

EXCESSIVE FUEL VAPOR PRESSURE CAN OCCUR.