Latest vehicle recalls

The alloy a-arms may have a manufacturing casting defect and could crack and break after mileage accumulation.

Due to high loads on the upper rear radius rod, which is used to locate the crive axle and limit vehicle roll during turning manuevers, the upper rear radius rod may fail.

FURNACE PLYWOOD COVER WAS NOT INSTALLED.

Trucks will experience reduced braking at low brake application pressures when operating in the bobtail mode.

Wiring harness for the headlamps may break due to the stress created by the headlamp pop up devices.

Fuel line routing could allow the line to contact the electrical connection on the starter solenoid.

Fuel pump breather tube routing may cause air/fuel mixture to be ignited by the arcing of the contacts in the electrical fuel pump.

The steering gear mounting bracket welds may crack under certain steering load conditions.

The electronic air conditioning control may not function when starting car that has been parked for a few hours with ignition off.

Under certain vehicle load or road conditions, a section of the front suspension support, at level of the bearing pivot, may crack or break.

Cruise control system is susceptible to water contamination and, if it becomes wet while in use, could create a short circuit.

Loose retaining nut on steering wheel could cause the steering wheel to feel loose.

Shields on the fronts of the midship mounted fuel tanks were omitted during assembly.

Premature wear in the idler arm pivot bearing and or ball joint attachments could occur.

Misrouting of turbocharger oil feed pipe could allow pipe to contact the positive battery cable connecting stud on the starter motor.

Tire size data on certification label is incorrect.

Front wheel bearing adjusting nut retaining keys may be missing from front axle assemblies, allowing the nut to loosen.

Inadequate heat shield above catalytic converter could overheat.

Under certain circumstances, the tv monitors may fall from their receptacles.

Under certain conditions, a reverse current might flow through a wire cable between the air recirculation switch and a microswitch.