Latest vehicle recalls

The exhaust gas recirculation manifold core plugs may become displaced resulting in a loss of engine vacuum and subsequent stalling. This would produce immediate erratic engine operation and subsequent loss of power brakes and power steering assist.

The upper support strap nuts, attaching the fuel tank, were not tightened to specifications. This may allow the fuel tank to detach and fall to the ground.

On the involved vehicles, the fifth wheel may have a cracked tube. A cracked cross tube may lead to failure of the fifth wheel.

On the involved vehicles, the windshield opening may be slightly oversized, which could allow the windshield glass to dislodge from its base.

The involved vehicles do not conform to federal motor vehicle safety standard no. 101, "Controls and displays". The vehicles were manufactured with an optional adjustable hand throttle that was not labeled as required.

The center (spider) section of wheels installed on these vehicles may have been manufactured from an incorrect grade of steel. The center section may fatigue and separate from the wheel rim.

A short circuit may occur in the manually operated choke override mechanism. This could cause the override mechanism housing and outer cover of the choke cable to melt and burn.

On the involved vehicles, the accelerator cable may have an overly long plastic sleeve at its carburetor end. This could allow the sleeve to become stuck in the end-fitting when the accelerator pedal is pressed to the floor. This would cause the throttle to...

The steering column adapter can contact and eventually cut through the steering shaft.

The involved vehicles do not conform to federal motor vehicle safety standard no. 120, "Tire selection and rims for motor vehicles other than passenger cars". These light trucks were incorrectly classified as passenger vehicles and were equipped with load...

The involved vehicles do not conform to federal motor vehicle safety standard no. 207, "Seating systems". The self-locking latch that retains the driver"s seat in its upright position under vehicle impact conditions may fail due to improper heat-treatment.

The left front tire may hit a structural crossmember when driven over a bump in the road. If the front tire should contact the crossmember, the motorhome may be pulled to the left and into the lane of oncoming traffic. This will be magnified if the air bags...

The involved vehicles may have been built with left door lock assemblies that contain pawl spring retainers that were not produced to engineering specifications. Consequently, the spring could break, causing the latch pawl to disengage from the latch cam.

The seat back pivot pin bracket on the involved vehicles may fail. Consequently, the seat back will rotate rearward.

The wheels on the involved vehicles may be equipped with an improperly formed spider in the area where the spider attaches to the rim. Consequently, the center section of the wheel may develop cracks and separate from the wheel rim.

The required muffler to floor pan heat shields were omitted from the involved vehicles. These heat shields are necessary to protect the passenger compartment interior materials, including seat belt webbing, from heat damage.

The front driving axle wheel hubs on the involved vehicles may fail due to improperly machined spindles. This error may prevent the wheel hub and bearing from seating properly, causing bearing failure and eventual hub fracture. Also, the front wheel could...

The involved vehicles do not conform to federal motor vehicle safety standard no. 121, "Air brake systems". The incorrect brake linings were installed on these vehicles. This could lead to increased stopping distances.

On the involved vehicles, the incorrect steering linkage assembly may have been installed. As a result, the right-hand steering tie rod might interfere with the intermediate rod. This could cause the connection to fail due to excessive stress at that point.

On the involved vehicles, the incorrect fuel hose pipe was installed. Consequently, the needed special reinforcement, used to help prevent rupture of the hose and spillage of fuel resulting from an impact from the side, was omitted. This would constitute a...