the TGV valve metal flap screw came undone and came loose with the intake manifold. piece of metal about 1 in x 2 inch (flap) fell down to cylinder 2 intake and rubbed against the intake valve nipping pieces off and those pieces of metal along with loose screw fell chipping corner of cylinder 2 top edge. at my shop they had to replace cylinder 2 and TGV valve and rebuild the damaged cylinder head. REASON WHY I TOOK IT TO THE SHOP There was small vibrations at a idle at about 800 rpm (stationary) and already...
Read the full complaint
replaced the spark plug and fuel injector and it still shook little bit. since i couldn't figure out what was the issue decided to take it to a mechanic. about a week prior to dropping the car off at the mechanics I heard a metal clinking in the engine for a minute and went away. after that the Miles per gallon went from 27 down to 25 miles per gallon. before taking the car to the shop there was a warning light on cylinder 2 on my OBDII reader ( not a full check engine light). a screw shouldn't be loosening in a internal combustion engine part where if not taken care of it can detonate an engine and cost user thousands of dollars and it was not their fault. I researched on this same issue and I found few online where they were showing videos of them moving the loose part with a screw driver. Have not found any one where the part came off completely and went down into the intake valve.