During the turns the steering wheel in 2018 Chrysler Pacifica Hybrid locks-in. It requires extra force to unlock the steering wheel. This usually happens when the wheel is at 11 or 1 o'clock (30 degrees either direction). This is more noticeable at slow turns like on exit ramps.
Wheels & tires
Chrysler Pacifica Tire problems by year
98 complaints filed with NHTSA about the Chrysler Pacifica's wheels & tires. Tire failures, tread separation, wheel bearings, lug nuts, rims and tire pressure monitoring.
Tire complaints by model year
Latest Pacifica tire complaints
The contact owns a 2017 Chrysler Pacifica. The contact stated that the steering wheel was sticking intermittently while turning, causing the steering wheel to overcorrect after being turned. The TPMS warning light was illuminated. The local dealer was not contacted. The vehicle had not been diagnosed or repaired. The manufacturer was not contacted. The approximate failure mileage was 127,000.
On October 7, 2024, my vehicle was serviced at Coastal Chrysler Dodge Jeep Ram for a front-end rubbing/scrubbing noise that increased with speed. The dealer diagnosed both front hub assemblies as failed and replaced both front hub assemblies. I was charged a total of $2184.41 for the repairs, including parts and labor. In less than two years, I again experienced significant front-end noise and safety concerns. On May 19, 2026, because I urgently needed the vehicle and was unable to obtain a timely appointment with...
Read the full complaint
the dealership, I took the vehicle to a well-regarded independent repair facility, Koala Automotive Repair LLC. Their findings were extremely concerning. The mechanic documented that: The front wheel bearing was completely worn out. The axle had ripped due to contact with the strut assembly. Bolts on the hub bearing assembly were "very loose" and reportedly "finger loose" The vehicle owner stated that the hubs had recently been replaced by the dealership The independent mechanic further advised that the components replaced in October 2024 should still have been under dealer warranty, and that the second repair involved the same components and directly related failures. I am deeply concerned that: Components replaced by the dealer failed again prematurely; The loose hub bearing assembly bolts may indicate improper installation or insufficient torque procedures during the prior dealer repair; and The subsequent failure created additional damage to the CV axle and related front-end components. This situation caused: Significant unexpected repair expenses: I had to spend a total of $1,932.71 for the second repair. Loss of use of the vehicle. Safety concerns for myself and my passengers. Additiona
My 2018 Pacifica Hybrid suffered a catastrophic suspension separation while driving - the exact failure described in Safety Recall V15. The driver fortunately arrived at home safely only seeing smoke coming out form the tire rubbing against the wheel hood. Although my VIN isn't showing as 'active,' this is clearly a safety defect. I would like to open a case for a Goodwill Repair or a 'Special Policy' adjustment because this is a known dangerous failure.
The contact owns a 2021 Chrysler Pacifica. The contact stated that while driving approximately 30 - 35 MPH, there was an abnormal rattling sound coming from the wheel well or near the front underbody near the air dam, as if there was a piece of ice stuck in the air dam. The vehicle was taken to the dealer, who diagnosed that the front wheel hub hardware was loose, affecting the wheel bearings, and causing the failure. The contact was informed that the wheel hub hardware and front wheel bearings needed to be...
Read the full complaint
replaced, and the front wheels needed to be rotated. The vehicle was not repaired. The manufacturer was informed of the failure, and a case was opened. The failure mileage was approximately 20,000.
I noticed that my tire was getting flat at my aunt townhouse in nephi Utah. so I took it to the maverick gas station to get a better look at it and investigate the possibility of a leak in it put some air in it and then enough to make it rise and I leaned in close to listen to see if I can hear a leak and I could hear a sound, but I couldn't locate it and right when I was about to give up and actually move my head away from my tire. My tire exploded, giving me a major concussion to the point where two ambulance...
Read the full complaint
services were called. The police were called. I ended up going to the ER that night because I could not remember how to spell my name what day it was and where I was at exactly aka the hospital.
The vehicle is unsafe to operate and presents an immediate highway safety risk. Shortly after purchase, the vehicle experienced multiple safety-related failures. Headlights were inoperable from the time of delivery, requiring use of high beams at night to see the roadway. This created visibility and traffic safety issues from day one. Within the first month of ownership, the vehicle required towing. The vehicle is a hybrid and could not be shifted into neutral, yet it was dragged with the wheels locked during...
Read the full complaint
towing rather than transported on a flatbed. This caused damage to multiple systems. Following the tow, all four tires developed visible bulges consistent with being dragged while immobilized, creating a significant risk of tire blowout at highway speeds. Steering and alignment became unstable, with grinding noises and loss of predictable control. The hybrid underbody shielding was also damaged, leaving components exposed. These conditions have persisted despite repeated notice to the seller and service administrator. A repair facility has confirmed the vehicle is not safe for long-distance or highway travel. The vehicle must regularly be driven at interstate speeds, and continued operation poses a serious risk of crash or injury. The vehicle remains in service only due to lack of alternatives, despite known safety defects affecting steering, lighting, and tires.
The contact owns a 2024 Chrysler Pacifica. The contact stated that while attempting to make a left or right turn, there was an abnormal sound coming from the front driver's side wheel. The contact stated that while attempting to depress the brake pedal, the vehicle made the same sound. A dealer was contacted. The vehicle was taken to the dealer, where it was diagnosed and determined that the wheel hub was loose and needed to be replaced. The wheel hub was replaced, and the vehicle was repaired. The manufacturer was not notified of the failure. The failure mileage was 15,000.
Vehicle is new and delivered on 08/27/21. Complaint: The front axle nuts on vehicle loosen over time. The first incident was reported to I-10 Chrysler Dodge Jeep Ram on 09/29/23 (see Invoice), with 24,832 miles as a noise coming from the front left suspension. This dealer replaced both front hubs at that time which resolved the noise. The second incident was reported to Chrystal Chrysler Jeep Dodge Center on 02/13/24 (see Invoice) with 27,952 miles as a noise coming from front left axle. Dealer mechanic went on...
Read the full complaint
test drive with me and found noise coming from front left axle shaft nut. RO states, "Found axle nut not torqued to specs. Tight down left front axle nut. Test drove vehicle. No noise found after repair.". The third incident was reported to Hemet Chrysler Dodge Jeep Ram on 08/26/25, and I asked them to check the torque on the front axle nuts. They told me that the odds that they would be loose again was very small and they would need 2 days to diagnose the issue. Because I was leaving for a vacation road trip with the vehicle within a few days, I decided to take it to an independent automotive shop (Cam Stones Automotive Inc.) on 08/26/25 and reported that the vehicle has a history of the axle nuts loosening over time. I asked that they check the torque on the front axle nuts (see Invoice). The invoice states, "Retorque axle nuts and apply lock tight. Suggest contact dealer or NHTSA as to permanent fix. 120 Ft. Lbs.". As I'm sure you are aware of the danger in axle nuts that loosen over time. Is there a Recall on this issue? If not, are you investigating complaints of the axle nuts loosening time and time again?
The van was going about 10 mph and the side wall just burst and went to flat right away and tire pressure warning came on. Yokohama had a recall for this same issue in 2022 but this DOT was not included. Nothing came in contact with tire or van when the issue occurred. This would have been a major issue if going full speed. Discount tire in Southaven MS stated the tire just gave out with no indication of anything hitting the tire. Yokohama refused to do anything as this is a BraunAbility handicap van which shows...
Read the full complaint
them as owner 1 to do the conversion through Chrysler. These Vans cannot be purchased through Chrysler directly. Yokohama did now even offer to report this issue internally as a complaint on the tire. I kept the tire for further inspection and investigation. I also have pictures and video of the tire prior to replacement. Tire Yokohama AVID S34 (S34RV) 236/65R17 104T. The P style is not indicated on the tire. I have 3 other tires remaining on the van with same tire/DOT (DOT 4UL8-PKX3321
A clicking sound was heard and the dealer determined that the front axle nuts that hold the wheel hubs to the axle loosened. Dealer re-torqued to 120 ft. Lbs. and added Locktite, however problem reoccurs. Chrysler issued a Technical Service Bulletin (03-008-24) to torque the axle nuts to 228 ft. lbs. After this was done at the dealer, clicking sound was heard again in just 3 weeks. Several attempts by the dealer to correct the problem at the 120 ft. lbs. spec. and once at the 228 ft. lbs. spec. have not worked following Chrysler's instructions. Risk of hub and wheel coming loose while driving. Dealer has attempted repair/correction six (6) times.
While I was driving the right control arm seperated from the car. I was fortunate that I wasn't on the highway, also that I did not cause a collision with another car/person. With no warning the car felt as if it dropped on to the ground. Soon after I received an error message saying to service the brakes which i assume was also damaged when the control arm fell... I had to have the car towed to a repair shop and received a list of repairs. The car is avaliable for inspection. I had no clue how something like...
Read the full complaint
that could even happen. Ive been trying to find answers when i saw a recall on another car by the same maker that perfectly summed up what happened to me. Chrysler's number for this recall is V15.
Been complaining about his front steering key suspension since 2020 about rattling and squeaking whenever customer turn in the wheel
Car would make a grinding noise over 5mph. We looked under the vehicle to find a loose bolt to the left of the left tire.
The rear subframe holding the rear axles suddenly broke in half while driving 30 miles an hour down a residential street. Luckily, I was able to control the vehicle to get it to a shop where it was replaced. The vehicle had never been in a wreck.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data