2016 Ram 2500 Problems, complaints & recalls

for approximately two weeks without experiencing any transmission problems. Before the recall update, the truck shifted normally and had no check-engine light or noticeable transmission slipping. Immediately after the PCM update, I began experiencing the following problems: * Transmission slipping in 5th and 6th gears. * Engine RPM increasing without the truck gaining speed. * Sudden loss of pulling power. * Transmission slamming hard when the gear catches. * Diagnostic trouble code P0740. I returned to the dealership and was told that the PCM accepted the software update and that it installed correctly. However, the vehicle was never road-tested after the update. I understand that the vehicle has high mileage, but the transmission was operating normally before the recall service. I am requesting: 1. A complete transmission diagnostic. 2. Verification of the PCM calibration and software compatibility. 3. Investigation of the relationship between the PCM update and the transmission symptoms. 4. A road test with diagnostic equipment, if safe. 5. A technical assistance case with Stellantis. 6. A written explanation of the findings and recommended repairs. I am not asking anyone to assume responsibility without an investigation. I am asking that the sudden change in vehicle operation immediately following the recall service be taken seriously. Please document this complaint and provide a written response. Thank you.

driving, including on the interstate, the truck would suddenly jerk, the RPMs would rise quickly, and the truck would lose speed. On several occasions, traffic behind me had to react quickly to avoid hitting me. The dealership told me the solenoid installed during the U29 repair was defective and replaced it with another solenoid. The same problems continued. The truck later developed code P0871, became undriveable, and was towed back June 1. The original transmission ultimately failed. The dealership then installed a Mopar remanufactured transmission. I picked it up June 13. Within roughly 600 miles, it developed substantially identical symptoms and failure patterns, including P0870 and P0871, limp mode, and another major transmission failure. It was towed back June 24. The dealership later found the overdrive clutch had disintegrated and metal was present in the transmission fluid. The failed remanufactured transmission is now being handled under its Mopar warranty, and the dealership is looking to install a third transmission without identifying a clear reason for the repeated failures. I am concerned the same problem could happen again and believe the U29 repair, replacement parts, or another related transmission problem should be investigated.

inspection. This vehicle is equipped with a steering-column-mounted automatic transmission shifter. I am concerned that the incident may involve the transmission/shift interlock/Park system. I am aware of NHTSA Recall 17V-821 (FCA T79), involving unintended rollaway in certain Ram trucks, as well as NHTSA Recall Query RQ25003 concerning reported BTSI failures in vehicles including Ram 2500 models. The NHTSA VIN lookup currently shows zero unrepaired recalls for this vehicle; however, I do not yet know whether the prior T79 recall repair was performed on this specific vehicle or when it was performed. I did call the dealership and they said possibly 0ctober 3, 2018. I am submitting this complaint because the vehicle rolled after the driver reports placing the transmission in PARK and exiting the vehicle.

according to them I'm SOL and the dealership can align it but other shops are saying that you can't truly align the car and steering with that fix in place. I would hope that you put pressure on them to make this right.

opened with Ram Corporate Customer Care. Upon notification of the corporate escalation, the owner/general management of Hendrick Chrysler Dodge Jeep Ram in Hoover, AL placed a direct phone call to the consumer. During this conversation, the dealership owner explicitly and aggressively stated that the dealership would do anything they had to do to get out of fixing the mistakes made on the drag link, directly refusing to authorize a safe flatbed tow, refusing to replace the ruined, improperly welded linkage, and refusing to assume liability for the three structurally destroyed tires. REQUESTED REMEDIAL ACTIONS The complainant requests that the National Highway Traffic Safety Administration (NHTSA), the Federal Trade Commission, and the Alabama Attorney General's Consumer Protection Division launch an immediate investigation into Hendrick Chrysler Dodge Jeep Ram for faulty execution of federal safety mandates, reckless endangerment of motorists, and bad-faith commercial practices. The dealership must be held legally and financially accountable for: The immediate cost of a flatbed tow from the vehicle's stranded location to a certified repair facility. The complete removal of the ruined, welded steering components and the installation of Ram's updated, factory-authorized non-welded, clamp-style drag link assembly. The complete financial reimbursement or replacement of three (3) structural tires destroyed as a direct consequence of the failed recall execution.

error messages, creating a constant distraction that takes my attention away from the road. When these issues occur, the factory backup camera is unavailable. Losing the backup camera eliminates an important safety feature intended to help prevent collisions with pedestrians, children, vehicles, and objects while reversing. Additionally, the factory navigation and GPS no longer function at all. These are not minor convenience issues - they are daily safety concerns. Safety-related features should work immediately every time the vehicle is started. A factory infotainment system that fails every day, disables the backup camera during startup, and repeatedly distracts the driver while the vehicle is in motion presents an unacceptable safety risk. Because these failures occur daily and involve factory-installed safety equipment, I believe Stellantis should replace the defective Uconnect radio at no cost. I respectfully request that this complaint be documented and that a no-cost replacement be authorized. Thank you for your prompt attention to this matter. [[redacted]] VIN: [[redacted]] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

to the dealer, however the contact was informed that the recall repair was completed in July 2019. The vehicle was not repaired. The manufacturer was made aware of the failure but provided no assistance. The contact was informed that the recall repair was covered under warranty for two years from the date of completion. The contact stated that the recall repair was not performed, but marked as completed by the dealer. The failure mileage was approximately 97,000.

failure. The vehicle was taken to an Auto Parts Store and diagnosed using a handheld scanner, and a fault code associated with the turbo actuator for the diesel engine was retrieved. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The contact called a local dealer and was notified of Technical Service Bulletin Number: 09-005-22; however, the vehicle was not included. The manufacturer was informed of the failure and referred the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 113,000.

in half at the point where the shift rod inserts into the bracket. This mechanical failure rendered the vehicle inoperable and unable to be shifted out of Park. No warning lights or prior symptoms were observed before the failure. The broken part was visually inspected and confirmed to be the shifting lever bracket, consistent with Mopar part number 68470756AA. Immediate Actions Taken The vehicle was safely secured to prevent unintended movement. Engine was turned off and keys removed. Visual inspection confirmed that the shift lever bracket had broken at the rod insertion point. Tow service was arranged for transport to a repair facility. Photographs of the damaged bracket and shifter assembly were taken for documentation. Assessment This incident represents a critical component failure of the gear shift mechanism, resulting in sudden loss of control over transmission operation. The break occurred under normal shifting force, indicating a possible material or design defect in the bracket assembly. Recommended Actions File a warranty or recall inquiry with Ram/Stellantis regarding potential defects in part 68470756AA. Replace the damaged bracket with a verified OEM replacement. Inspect surrounding linkage and cable components for stress damage or misalignment. Retain the failed part for potential recall or manufacturer investigation. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

What broke was the plastic that holds two screws in. Hopefully no one gets hurt if others break. In my opinion it seems like a bad design to save money. The replacement part by the way is $313.00 for plastic with leather wrapped handle. I was willing to spend that but the attitude I got from Stelantis was very non caring after I spent $60,000 on a truck in 2016. I ordered this part in May of 2025 then in August they told me it was discontinued.

replacement as well. They were three weeks out for labor. I contacted a local diesel repair shop who purchased the turbo and actuator from Larry Miller Dodge Ram and had it installed in a day. Subsequent to these repairs ($5,400.00) I have learned that MOPAR issued Warranty Bulletin D-22-06, dated March 16, 2022, for the same make and model as mine, only for the year 2015. My truck was built in 2015 and the parts and computer codes for failure are identical. This published warranty bulletin issued relief of a new extended warranty of 15 years /150,000 miles for the installed turbo actuator/turbo. Since mine failed at 48,000 miles, this could be a continuation of the aforementioned issue with the stated 2015 year failures. I was lucky I didn't create a traffic accident when this turbo system failed since it was sudden and violent when the loss of power occurred without warning. I'm asking you to probe or look at the facts that the issue with these Garrett turbos are still outstanding whether Doge/Ram/Fiat/Mopar wants to include them in their campaign. The danger is real. The costs to retired people, such as myself, is consequential and devastating. It is unfair there is no way of sending queries to the manufacturers to alert them of this condition. The only way to communicate is to talk to a person in India and the communication barrier is tremendously difficult as is the chance of getting any return on the days and weeks of attempts for resolution.