On certain transit and school buses, a brass fitting connects the double check valve to the brake relay valve. With certain inputs to the vehicle, the weight of the check valve on the fitting can cause the assembly to resonate. The subject vibration can...
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
On certain trailers equipped with bendix sr-5 trailer spring brake valve assemblies, the molded rubber face of the inlet/exhaust valve (i/e valve) component of the affected valves can separate from the valve's metal insert. Air can be trapped by a separated...
On certain trailers equipped with bendix sr-5 trailer spring brake valve assemblies, the molded rubber face of the inlet/exhaust valve (i/e valve) component of the affected valves can separate from the valve's metal insert. Air can be trapped by a separated...
On certain passenger vehicles, the engine auxiliary/cooling fan operation, including variable speed, is electronically controlled. Failure of the fan motor can cause the electrical circuitry of the fan control unit to overload and fail, causing the fan to...
On certain minivans equipped with child restraint anchorages (tether anchorages) for use in conjunction with child restraints installed in the three rearmost seating positions, the "safety first" portion of the owner's manual delivered with these vehicles...
Covers2001 Volkswagen Eurovan
On certain sedans, coupes, hatchbacks, and sport utility vehicles, electrical contacts in the ignition switch can degrade due to the high electrical current passing through the switch when the vehicle is started.
On certain buses equipped with electronic throttle control/accelerator pedals supplied by williams controls industries, the weld attaching the clevis to the plate has insufficient penetration and could allow the clevis to separate from the plate.
On certain passenger vehicles built by mitsubishi motor corporation for daimlerchrysler, a condition exists that allows oil to leak from the all-wheel drive transfer case.
On certain passenger vehicles, a condition exists that allows oil to leak from the all-wheel drive transfer case.
On certain passenger vehicles, during the manufacturing process, oil was applied to the brake pedal assembly to prevent rust. This oil can leak into the brake stop switch and contaminate the electrical contacts.
Certain heavy duty trucks, truck tractors, and buses equipped with 195/75r22.5 Tires mounted on 7.5 Inch wide wheels fail to comply with requirements of federal motor vehicle safety standard no. 120, "Tire selection and rims for motor vehicles other than...
Certain passenger vehicles fail to conform to the requirements of federal motor vehicle safety standard no. 201, "Occupant protection in interior impact."
Certain passenger vehicles fail to conform to the requirements of federal motor vehicle safety standard no. 201, "Occupant protection in interior impact."
On certain sport utility trailers equipped with an optional cargo bay wall, the cargo bay wall includes a lockable door. If the door is locked and there are occupants inside the compartment, there is only one exit, the emergency egress window.
On certain motorcycles, the fuel rail assembly contains a schrader valve that permits a diagnostic check of fuel pressure at the fuel rail during engine operation. If the schrader valve is not properly tightened, fuel leakage could result.
On certain motor home chassis, the welds where the liquid propane (lp) gas tank bracketing joins the floor trusses may not be adequate.
Some steel kingpins supplied by custom forge, for use on certain van trailers, have been determined to possess inadequate heat treatment.
Certain motor homes equipped with certain drag links, tie rods and ball socket bearings, part no. Trw 24 dl, supplied by holland neway and manufactured by trw. These steering components have a below specification case depth and/or hardness which can lead to...
On certain motorcycles equipped with rear shock absorbers made by sway-a-way, the bolts that mount the rear shock absorbers to the swing arm could break.
On certain light duty pickup trucks, the latch plate used in the seat belt buckle was not manufactured according to design dimensions. If the seat belt tongue is inserted slowly at an angle into the buckle, there is a possibility of partial engagement.