On certain sport utility vehicles, the passenger air bag wiring harness was improperly manufactured.
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
On certain trucks, the cotter pin that goes through the drag link ball stud at the connection to the pitman arm is missing. This pin prevents the castle nut from loosening.
Certain trucks equipped with engine starters (code 08wwn or 08wwp) built by leece-neville. These starters have a defective terminal adapter stud. The stud is used only at the positive battery connection to the starter solenoid. It was designed to be...
Certain class a motor homes equipped with an electdraulic-braking device built by ausco. When activated, the master cylinder applies the brakes on the tag axle. If the motor home is traveling, the tag axle brakes could lock-up.
On certain buses equipped with electronic throttle control/accelerator pedals supplied by williams controls industries, the weld attaching the clevis to the plate has insufficient penetration and could allow the clevis to separate from the plate.
On certain passenger vehicles, the engine ground strap was manufactured improperly. As a result of the improper "crimping" of the ground strap connectors to the braided ground strap, the engine ground strap may not provide the proper electrical ground...
On certain motorcycles, fractures can occur on either the left or right fuel tank at the top of the joint where the bracket is welded to the tank back plate.
On certain heavy duty trucks equipped with dana spicer tandem drive axle models ds463, an undersized attachment weld may fracture without warning.
On certain transit buses equipped with adhesively bonded aluminum bus door panels, due to an imperfect bonding of the door panel skin to the panel frame, environmental moisture may infiltrate regions of imperfect bonding and cause separation of the frame and...
On certain motor coaches/motor homes equipped with electronic throttle control/accelerator pedals supplied by williams controls industries, the weld attaching the clevis to the plate has insufficient penetration and could allow the clevis to separate from...
On certain bumper-pull horse trailers, the safety cables, used to maintain a connection between the trailer and tow vehicle, are not equipped with thimbles and thus do not conform to sae j684.
On certain trucks, a capacitor in the power line control (plc) filter could overheat and/or ignite when subjected to reverse polarity electrical spikes.
On certain school buses, misalignment of the fan drive system components can cause premature belt and pulley bearing wear.
Certain mini vans fail to comply to the requirements of federal motor vehicle safety standard no. 120, "Tire selection and rims for motor vehicles other than passenger cars." An incorrect gross axle weight rating (gawr) was indicated on the certification...
Certain heavy duty trucks converted from sleepercabs to day cabs and equipped with a detroit diesel optimized idle system. The idle system was not completely disabled in the cab conversion process.
On certain motorcycles, the fuel tanks may have been improperly mounted to the motorcycle. This can put unnecessary stress on the tank mounting tabs, causing these tabs to fail, with the possibility of fuel spillage.
On certain passenger vehicles, the lower steering column shaft coupling may have been installed onto the input shaft of the steering rack with too much clearance between the bottom of the coupling and the steering rack input shaft housing.
On certain travel trailers, the electrical wiring installed in the rear of the refrigerator compartment could contact the top metal fins of the refrigerator condenser coil. The heating coil and fins could reach temperatures that approach the temperature...
On certain passenger vehicles, a problem in the manufacturing process of the rear brake rotors may have resulted in the creation of a crack where the brake disc and the parking brake drum meet. Further cracking of the rotor could occur due to braking torque...
On certain transit buses equipped with vanner 60 series battery equalizers, the equalizer could fail to operate properly and cause malfunction of the battery charging system.