Latest vehicle recalls

On certain school buses, galvanic corrosion on the die cast adapter plate causes distortion of the wagon wheel seals that are mounted on the adapter plate. If the seals become distorted, the tipper valves cannot properly seat against the wagon wheel seals...

On certain heavy duty trucks equipped with iros rear air suspensions, during assembly, four bolts and nuts holding the main support member bushing bar pins to the main support member hangers were incorrectly tightened.

On certain sport utility vehicles, if a driver has not placed the shifter lever fully into the "park" position and leaves the vehicle running, the vehicle may unexpectedly move rearward after seeming to be stable.

On certain low floor transit buses equipped with adhesively bonded aluminum bus door panels, due to an imperfect bonding of the door panel skin to the panel frame, environmental moisture may infiltrate regions of imperfect bonding and cause separation of the...

On certain passenger vehicles equipped with an electronic throttle control system, the stopper for the accelerator pedal will prevent excessive movement of the accelerator position sensor. If the driver applies overly excessive force to the accelerator pedal...

Vehicle description: motor homes. The steering gear box is mounted on a support located under the driver's seat floor. On motor home models, this support varies in height with the optional interior height. With 83 and 86 inch height options, the support...

On certain heavy duty trucks equipped with meritor wabco pneumatic anitlock brake system (abs) valve packages, the assembly bolts on these valve packages were not tightened correctly.

Certain sedans and coupes fail to comply with the requirements of federal motor vehicle safety standard no. 209, "Seat belt assemblies." Certain rear seat belt buckles were improperly manufactured.

On certain passenger vehicles, the left lower instrument panel bracket was not installed.

On certain pickup trucks, the alternator wire connection to the power distribution center (pdc) can loosen.

On certain sport utility vehicles equipped with manual transmissions, the parking brake can self-release without warning.

On some class a motor homes, an incorrect flex hose assembly and fitting was mated to the side room bulkhead connector.

Some motorcycles may have a gas tank venting system that became clogged during production.

On certain heavy duty class 8 trucks, the forward and/or rear drive axle upper axle seat can break allowing the axle to shift out of alignment.

On camping trailers equipped with lift systems provided by goshen stamping company and winches supplied by dutton-lainson company. The winches included in the roof lifter systems of some of these trailers have an inadequate weld to the gear, so that a raised...

On some manual transmission trucks equipped with the fx4 package, the rear axle differential case could fracture under a high torque event such as when customers accelerate rapidly from a stop or when a spinning tire suddenly gains traction.

On some heavy duty trucks equipped with alcoa fujikura ltd. (Afl) power distribution boxes (pd box), the pd boxes were manufactured with insufficient torque applied to the nut of the main power feed-through stud.

On certain terminal tractors built with a steerable auxiliary axle and equipped with certain meritor-wabco brake system two and four port relay valves, the valve may stick open when a high-pressure application is released.

Certain trailers equipped with pintle hook assemblies may have unacceptable weld attachments to the trailers.

Certain sport utility vehicles equipped with a fuel tank brush guard fail to comply with the requirements of fmvss no. 301, "Fuel system integrity." The onboard refueling vapor recovery (orvr) control valve can become detached during a crash, allowing fuel...