On certain coaches and bus shells equipped with electronic throttle control/accelerator pedals supplied by williams controls industries, the weld attaching the clevis to the plate has insufficient penetration and could allow the clevis to separate from the...
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
On some travel trailers equipped with optional underslung spare tire carriers, the locking pin for the spare tire carrier may not have been installed.
Certain light duty pickup trucks equipped with a heavy duty service package fail to comply with the requirements of fmvss no. 120, "Tire selection and rims for motor vehicles other than passenger cars." A typographical error occurred resulting in an...
Covers1999 Ford F-150
On class a motor homes built with a steerable auxiliary axle and equipped with certain meritor-wabco brake system two and four port relay valves, the valve may stick open when a high-pressure brake application is released.
The steering knuckle castings on certain passenger vehicles may have been contaminated during the casting process.
Covers2002 Saab 9-5
Certain motorcycles were built with a front shock mount that is cracked and could break allowing the suspension to drop unexpectedly.
On certain motorcycles, the clips that retain the wiring for the front fender tip light can become detached from the fender, causing the wires to fray and short.
On certain motor homes built on prevost chassis, the steering gear box is mounted on a support located under the driver's seat floor. On motor home models, this support varies in height with the optional interior height. With 83 and 86 inch height options...
Vehicle description: taurus/sable vehicles equipped with 3.0L and 3.8L engines and mustang vehicles with 3.8L and 5.0L engines. It is possible for the engine cooling fan bearing to seize.
Vehicle description: trucks equipped with e-tech engines. A condition exists on the auxiliary drive shaft of the e-tech engine that causes the loss of power steering on vehicles where the power steering pump is mounted off the front of the engine.
This is not a safety recall in accordance with the safety act. However, it is deemed a safety improvement campaign by the agency. Vehicle description: 1995 taurus/sable passenger vehicles equipped with 3.0L and 3.8L engines and 1995 ford mustang vehicles...
Motorhomes equipped with drag link assemblies containing 20-edl model ball sockets and manufactured by trw. Certain of the tie rod ball-socket bearings have a below-specification case depth and/or hardness, which can lead to premature wear of the socket.
Vehicle description: certain sport utility vehicles fail to comply with the requirements of fmvss no. 210, "Seat belt assembly anchorages." Some vehicles were produced with rear outer seat belt shoulder guide anchor bolts that were incorrectly installed.
Covers2002 Saturn Vue
On certain trucks equipped with caterpillar 3406e and c-15 engines, interference between the positive battery cable and stud mounting electronic control module (ecm) to the engine exists. Chafing can wear through the battery cable insulation to allow contact...
Vehicle description: certain mini vans without anti-lock braking systems (abs) fail to comply with the requirements of federal motor vehicle safety standard no. 135, "Passenger car brake systems." Due to inappropriate brake pipe layout, these vehicles do...
Vehicle description: certain buses fail to comply with the requirements of federal motor vehicle safety standard no. 120, "Tire selection and rims for motor vehicles other than passenger cars." The tire placard label contains an incorrect recommended cold...
Vehicle description: certain mini vans built with second row 50/50 split bench seats or captain's chairs, fail to comply with the requirements of fmvss no. 225, "Child restraint anchorage systems." The seat latch anchor wire diameter is greater than 6.1 Mm.
Vehicle description: certain sedans and coupes fail to comply with the requirements of federal motor vehicle safety standard no. 209, "Seat belt assemblies." Certain rear seat belt buckles were improperly manufactured.
Vehicle description: fire truck chassis with caterpillar 3126 engines. The alternator cable was routed over the top of the alternator, and in some cases, allowed the cable to make contact with and wear on structural members of the engine enclosure.
Vehicle description: certain passenger vehicles fail to conform to the requirements of fmvss no. 208, "Occupant crash protection," and no. 214, "Side impact protection." These vehicles may have welds near the lower driver's side door hinge that do not meet...