Latest vehicle recalls

Vehicle description: heavy duty trucks converted from sleeper cabs to day cabs fail to comply with the requirements of fmvss no. 210, "Seat belt assembly anchorages."

Vehicle description: minivans equipped with an adjustable pedal option. The driver floor mat could interfere with the accelerator pedal.

Vehicle description: motor homes equipped with safety belt assemblies produced by am-safe. On some seat belts, the buckle and connector may unlatch during a collision.

Vehicle description: passenger vehicles. The engine auxiliary/cooling fan operation, including variable speed, is electronically controlled. Failure of the fan motor can cause the electrical circuitry of the fan control unit to overload and fail, causing...

Vehicle description: passenger vehicles (allroad). When activating the windshield wiper under heavy load conditions such as freezing, snow or heavy rain, one wiper could be delayed behind the other wiper.

Vehicle description: heavy duty class 8 trucks. The wrong steering column to steering gear shaft may have been installed in these vehicles. Using the shorter vnm steering shaft could result in steering shaft being operated (steering column extended...

On certain minivans originally sold in or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode...

Vehicle description: certain motor homes do not comply with the requirements of federal motor vehicle safety standard no. 120, "Tire selection and rims for vehicles other than passenger cars." The front axle weight rating (fawr) is inadequate.

Vehicle description: sport utility vehicles. Due to an assembly error, one or both self-locking nuts that secure the pedal assembly to the booster may have been cross-threaded on the booster studs that protrude through the firewall. In such a case, the...

Vehicle description: 4.4I sport utility vehicles. Over an extended period of time, abrasion particles could deposit on the electrical contacts within the switch, causing a disruption of the electric current through the contacts. If the disruption occurs...

Vehicle description: 4.4I sport utility vehicles. There is a plastic carrier to which the oil filter housing is attached. Oil supply and return lines are attached to the filter housing. Over time, this carrier could sag slightly. If this happens, one of...

Vehicle description: vehicles equipped with certain haldex brake system two and four port relay valves. The valve may stick open when a high-pressure application is released.

Vehicle description: trailers. Some of these trailers have non-reflective side clearance lights.

Vehicle description: certain vehicles having an intended service code of "fire service" and either type 24 or larger front brake chambers or type 36 rear brake chambers fail to comply with requirements of fmvss no. 121, "Air brake systems." These vehicles...

Vehicle description: school and transit buses equipped with rear mounted engines. The 12-volt power supply cable(s) may be chaffed by hoses, harnesses, frame components, or clamps.

Vehicle description: 28' van trailers supplied to motor cargo, inc. Cracks have occurred in the crossmembers above the suspension.

Vehicle description: heavy duty vehicles equipped with a 20,000 pound rated dana i-200 front steer axles. There are visible cracks in the seal diameter and large bearing diameter on the front axle knuckles, which can reduce the life expectancy of the...

Vehicle description: 4x2 trucks equipped with tu4 white letter tire upgrade option and distributed by southeast toyota distributors in the states of alabama, florida, georgia, north and south carolina. Tire damage may have occurred due to improper...

Vehicle description: heavy duty 6x4 trucks equipped with chalmers 800 series suspension kits. These suspension kits may have insufficient penetration of the weld attaching the torque rod eye to the torque rod tube.

On certain sedans, a small amount of water may have been left in the fuel pump electrical connector after testing. This residual water could cause the fuel pump to fail due to corrosion.