Latest vehicle recalls

Vehicle description: sedans and coupes. The hose clamps on the filler neck tube have insufficient clamping force.

Vehicle description: vans. A substitute wheel lug nut tightening process may not have been sufficient to assure proper torque of the lug nuts.

Vehicle description: heavy duty trucks. A change in the internal linkage of certain cab doors has created a possible binding condition.

Vehicle description: certain passenger vehicles, located in puerto rico, guam and the american samoa, fail to comply with requirements of fmvss no. 201, "Occupant protection in interior impact." These vehicles exceed the maximum allowable head injury...

Vehicle description: certain passenger vehicles fail to comply with requirements of fmvss no. 201, "Occupant protection in interior impact." These vehicles exceed the maximum allowable head injury criterion value specified in the standard for...

Vehicle description: walk-in delivery vans supplied to fed ex (fed ex w700). A bolt and nut installed through the chassis frame rail to support a new seat mount design could have partially collapse a brake line as the nut was tightened on the bolt.

This is not a safety recall in accordance with the safety act. However, it is deemed a safety improvement campaign by the agency. Vehicle description: 2001 plymouth voyager, chrysler town & country, and dodge caravan/grand caravan mini vans that are not...

Vehicle description: school buses equipped with bus boy cross view mirrors fail to meet the requirements of fmvss no. 111, "Rearview mirrors." The left and right convex mirrors are located too low.

Certain motor homes fail to comply with requirements of fmvss no. 120, "Tire selection and rims for motor vehicles other than passenger cars." These vehicles have an inequitable weight distribution between the front left and right tires on the front axle...

This is not a safety recall in accordance with the safety act. However, it is deemed a safety improvement campaign by the agency. Vehicle description: 1998-2000 rodeo (ue) and amigo (ua) models equipped with 2.2L 4-cylinder engines. The timing belt...

Vehicle description: passenger vehicles. Due to an assembly error during vehicle production, any of the three bolts that secure the pulley to the pump may have been inadequately tightened.

Vehicle description: sport utility vehicles. The right side tires may have horizontal cuts on the edge of the tread that could have occurred during vehicle assembly.

Vehicle description: certain passenger vehicles fail to comply with requirements of fmvss no. 209, "Seat belt assemblies." Certain driver and passenger seat belt buckles were improperly manufactured.

Vehicle description: passenger vehicles. One or more of the three bolts used to attach each front suspension lower control arm to the body on the left and right sides may not have been properly manufactured.

Vehicle description: certain sedans, hearse, and limousine vehicles fail to comply with requirements of fmvss no. 201, "Occupant protection in interior impact." These vehicles have sunvisor center supports with certain radii less than the 3.2Mm required by...

This is not a safety recall in accordance with the safety act. However, it is deemed a safety improvement campaign by the agency. Equipment description: ford is replacing all firestone wilderness at 15, 16, and 17 inch tires mounted on ford trucks and...

Vehicle description: transit buses. There could be a casting defect in the left side spring tower. The spring towers support the vehicle structure, and failure of a tower could cause a sudden shift in the front axle.

Vehicle description: sedan and wagon passenger vehicles. A diode in the electronic climate control system may have a reduced service life.

Vehicle description: heavy duty trucks equipped with cummins isc engines. Diodes (electronic devices that restrict current flow) contained in the pre-heat circuit of certain engine wiring harnesses were not properly insulated during the harness...

Vehicle description: certain passenger vehicles fail to comply with requirements of fmvss no. 208, "Occupant crash protection." The air bag alert labels may not be permanently affixed as required by this standard.