2017 Ram 2500 Engine problems

The contact owns a 2017 Ram 2500. The contact stated that while driving 25 MPH, there was an abnormal sound coming from the vehicle. The contact stated that upon inspecting the vehicle, there was a squeaking sound coming from the coolant pump. The dealer was contacted by phone and made aware of the failure. The contact referenced an unknown recall; however, the VIN was not associated with a recall associated with the failure. The manufacturer was contacted by phone and made aware of the failure. The contact was advised to contact the NHTSA Hotline to report the failure. The failure mileage was approximately 120,000.

Motor completely over heated causing the hose to rupture underneath the intake manifold. Engine is unrepairable. Had to order new engine and a new intake manifold because it melted the current one. Also approximately 2 years ago, I also had to replace the transmission. This truck only has 155,000 miles in it and has had 2 major break downs. WHY? This truck is unsafe.

My turbo actuator failed and was replaced in February of 2026. This is the same part, manufactured the same year as the recall: LOP#09440301 Both the manufacturer and NHTSA knew of this problem for years, but only fixed a small portion of the impacted vehicles. Please make me whole and refund my expenses for this known faulty actuator and repair work. Let me know if there is anything more you need from me.

The contact owns a 2017 Ram 2500. The contact received notification of NHTSA Campaign Number: 24V896000 (Service Brakes, Hydraulic); however, the part to do the recall repair was not available. The contact stated that while driving at various speeds, the ABS and check engine warning lights illuminated. The vehicle was initially taken to the dealer to be diagnosed. The diagnostic test determined that there was a failure with the ECM. The ECM was replaced; however, soon after the repair, the warning lights returned...

My 2017 Ram 2500, 6.4L Hemi experiences warning lights which I'm told is caused by intermittent PCM failure. I'm told this can cause the truck to stall while in motion, refuse to start, or enter "limp mode". This amounts to a possible unsafe condition that can put myself and passengers at risk of property damage, bodily injury or worse. I brought the truck to Priority Automotive of Westerly, LLC on March 9, 2026 for diagnosis. Their diagnosis (attached) recommended replacing the PCM to correct (possibly),...

It is a known issue that 2017 ram 2500 diesels experience turbo or actuator failures at low mileage costing upwards of 8-10000 dollars in repairs. My ram only has 61000 miles and due to exhaust fluid requirements etc, premature failure is common. Owners should be able to extend the warranty to 15 years as Chrysler has known this issue and has failed to address it. The code is in the attached screenshot.

The contact owns a 2017 Ram 2500. The contact stated that while driving at various speeds, the vehicle hesitated to accelerate as intended while the accelerator pedal was depressed. The "Low Coolant" warning light was illuminated. The contact was able to pull over to the shoulder of the roadway. While inspecting the vehicle, the contact became aware that the vehicle was experiencing excessive coolant consumption. The vehicle was taken to a local dealer, where it was diagnosed that the EGR system had failed and...

When I have gone to slow down and try to stop, the vehicle has slide forward a fee times. I thought it was a little weird, but didn't think to much of it. After a while, my transmission started acting up as well. I will be driving down the road about 50-60mph and it will shift to 4th gear and not come out of 4th gear until stopped and shut off and restarted. I recently heard about the recall when I took my truck to the dealership that is close to where I am located at the moment. I decided to research about the...

I got a p2609 code when the check engine light came on. After researching the code it has been determined it is the bolt holding the grid heater in place has deteriorated and now my engine needs to be dismantled to repair the problem. These repairs are roughly $3000.00. Ram has been aware of this problem in their vehicles since 2007 models and it is still a problem they are not being held responsible for.

The contact owns a 2017 Ram 2500. The contact stated that while driving at highway speeds, the check engine, traction, and ABS warning lights illuminated. Once the warning lights had appeared, the speedometer, odometer, and cruise control functions failed to operate as needed. The contact also stated that the transmission failed to shift out park(P). The vehicle was taken to an independent mechanic, where a code reader determined that the failure was linked to the ABS control module. The contact then received...

The heater grid bolt busted loose ultimately resulting in total engine failure. The bolt went through the intake, beat cylinder 6 all to heck resulting in the piston going through the block and wrapping around the cam shaft. Over $20,000 in repairs later and I have a working truck again. This is a known issue. My mechanic has fixed several of these in the last year. If you own one of these trucks, it is only a matter of time before it happens to you.

The grid heater bolt failed and fell into the intake runner. The bolt then fell into the number 6 cylinder causing engine failure. The vehicle has 73554 miles on it. The grid heater bolt failure is a known problem and has been recalled on other vehicles.

Grid Heater bolt failure. Grid heater bolt is secured by a nut below intake area. The nut on bolt melts and causes pieces and shards into cylinder #6 if not fixed immediately. This is a terrible design and expensive fix. I am 3rd person to have this problem recently amongst my friends. Metal in side motors should not be melting and or rotting into cylinders. Please see attached pictures showing melted bolt and shards in the intake area. If this is a part that needs maintenance it should be listed in the scheduled maintenance somewhere

Lost diesel exhaust brake transmission down shifts trying to slow vehicle bolt in cold start heater plate dropped into engine via intake manifold causing extensive internal damage

The contact owns a 2017 Ram 2500. The contact stated that after starting the vehicle, the check engine warning light remained illuminated. The contact stated that a diagnostic scanner was used to retrieve DTC: P2609; which indicated a failure in the intake air heater system. The vehicle was not yet repaired. The local dealers were contacted and indicated that the part was not available to order. No further information was available. The manufacturer was not yet contacted regarding the failure or parts availability. The failure mileage was 123,200.

Cam shaft lobe rounded off, causing sudden loss of power and misfire on cylinder 7. The first time this happened there was no warning or signs of trouble. I was traveling at highway speeds and the vehicle violently shook and speed unexpectedly dropped. Had to limp the truck off the highway with choppy acceleration while the steering wheel shook. This could of easily caused a serious accident at highway speeds. The damaged cam shaft caused damage to cylinder 7. Cylinder 7 now has low compression. The check engine...

This is preventative for myself but multiple others have been affected by this manufacturing issue. The factory grid heater has a bolt and stud on the bottom side of it. From heat and deterioration the bolt has a tendency to fall off, which then sends it through the intake manifold where it winds up inside cylinder #6. See these links for more information: [[redacted]] [[redacted]] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owns a 2017 Ram 2500. The contact stated while driving at an undisclosed speed, the accelerator pedal was depressed; however, the vehicle failed to accelerate as intended. The contact stated that the failure occurred intermittently. The vehicle was taken to the dealer where it was diagnosed with a failed turbocharger and that the turbocharger needed to be replaced. The vehicle was repaired; however, the failure reoccurred. The vehicle was taken back to the dealer where it was diagnosed with a failed...

We bought our truck in August 2023. At the end of January 2024 a light came on saying we had 150 miles before the engine shut down to 5 mph. A week later we get a recall letter, and take it to a dealership, they fix the recall they said, but before we got home, the light came on again. They told us to drive it a few days and it might go off. It stayed on we took it back to dealership. The recall apparently says to reprogram the def system. That is not the problem. The dealership said they did their part. Carmax...

Failed part is the turbo actuator. I was towing an approximately 6000lb trailer when the turbo actuator failed. I lost both boost to control power and loss of the exhaust brake. I was driving in an area of steep inclines and declines, loss of the exhaust brake is the safety issue. The actuator issue caused the check engine light to come on and codes were thrown regarding the failed actuator.There were no codes or any advanced warning of the failed actuator. The codes came up when the actuator failed, no exhaust braking while driving down the mountain. I have replaced the actuator and the vehicle is now running fine with adequate acceleration and the exhaust break also works.

An oil leak has formed at 46k miles and it is dripping all over the engine and the entire under carriage of the truck. This is common in the 6.7 cummins. The truck is under warranty but mopar refused to fix the truck. The oil gets on things that cause smoking snd burning smells. This has caused the engine to lose oil pressure and shut off on the highway.

My 2017 RAM 2500 (VIN-HG607103) at 83,015 miles began throwing a code of P2609 which is an air intake heater issue. I found my air intake relay was not working. I replaced it and all good, until the code returned a little over a week later. I then tested the relay and found it good and began to research more to learn that I had the "Bolt of Death" occurring. The bolt on my grid heater plate was broken, however it had not dropped into my engine cylinder. Luckly it was fused to the heater grid plate still. If it had fell off, it would fallen into a cyclinder damaging it and the piston, blowing the engine. There are recalls on new trucks with this engine however not the 2017s yet.

Recently there has been a number of reports stating the Engine Pre-heater electrical connector has become corroded causing the connector to overheat, rust, and eventually dropping the bolt nut to fall into the intake manifold where the lose nut is succeed into one of the cylinders causing major mechanical damage to the diesel engine. One article was mentioned and posted on Bank Power website, article: RAM Insider Talks Bolt Failure, regarding the intake manifold part# 12B1023A163.

The contact owns a 2017 Ram 2500. The contact stated while jump starting another vehicle, the contact noticed that the oil dip stick was not secured. The contact pushed the dip stick back into place. On another occasion, the contact was having the battery changed and the oil dip stick was not secured again. The vehicle was not taken to the dealer. The manufacturer was contacted. The failure mileage was 95,000.

The contact's husband owned a 2017 Ram 2500. The contact stated that prior to the failure, the dealer replaced the crankcase filter and performed other unknown maintenance services. The contact stated that after her husband remotely started the vehicle, there was smoke coming from underneath the hood and smoke entered the cabin of the vehicle. The contact's husband opened the hood and noticed there were flames coming from the engine compartment. The contact's husband extinguished the fire with a hose. No injuries...