On certain pick-up trucks equipped with 4.7L engines, the generator wiring harness may short circuit due to contact with a valve cover stud.
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
The seat belt assemblies on certain motor homes fail to comply with the loop load requirements of federal motor vehicle safety standard no. 209. "Seat belt assemblies."
One (1) tank trailer, vin number 1pm53432021025056, equipped with bendix ec-30t electronic control unit (ecu), the high side power switch inside the ecu that controls the illumination of the trailer-mounted abs warning lamp may eventually become thermally...
On certain motor homes built with dewalt/power gear hydraulic hoses used for the slide-out rooms and leveling jacks, the crimping process for attaching the hose fitting to the end of the hydraulic hose was performed improperly.
Certain trucks equipped with nexgen liquid natural gas (lng) tanks are being recalled. The introduction of water into the discharge side of both the primary and secondary relief valves simultaneously and subsequent freezing in service can render the valves...
On certain sport utility vehicles and pickup trucks equipped with 5.3L (rpo l59) v8 engines, the engine fuel rail crossover tube retainer screws were not manufactured to specifications and may break.
On certain trucks, the power steering pipe clamp was not installed.
During an insurance institute for highway safety (iihs) offset frontal barrier impact test, it was determined that fuel tan damage could occur. On certain passenger vehicles, a vapor tube hose clamp that is located near the fuel tank may not be positioned...
On certain passenger vehicles, after prolonged exposure to heat, the fuel tank may seep or leak fuel at the points where the heat shield is attached.
On certain recreational vehicles equipped with vansco vmm 2820 modules, the module could experience an incorrect fault indication on its bi-directional ouputs (19 and 20).
On certain motor homes, depending on the floor plan configuration and options, the actual weight on the rear passenger side tires could exceed the tire capacity for those tires at the current cold inflation pressure setting.
Certain passenger vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 301, "Fuel system integrity" a valve on the fuel tank assembly may not close properly. If a vehicle rolls over and the fuel tank assembly valve is...
On certain motorcycles, the front wheel may contain a casting flaw which could result in a wheel failure.
Certain transit buses fail to comply with the requirements of federal motor vehicle safety standard no. 217, "Bus emergency exits and window retention and release." There is interference between the side destination sign and the window frame that will not...
Certain my 2005 blue bird all american model school buses manufactured from may 24 through july 12, 2004. These buses fail to comply with federal motor vehicle safety standard no 221, school bus body joint strength. The rivet pattern may be incorrect in...
On certain travel trailers, due to various factors, including excessive paint coating on the brake hub, the aluminum wheels could exhibit lessened clamping pressure between the aluminum wheel and the axle hub assembly.
On certain trucks equipped with a combination of caterpillar c11/c13 engines and an optional leece neville brushless alternator, a chaffing point may exist between a heat shield on the engine and the wiring for the alternator.
On certain travel trailers equipped with optional 6 gallon dsi gas/electric water heaters with remotely operated 110-volt water heater on/off switching, excessive heat can be generated at the wire connections to the water heater while the heater is being...
On certain class a motor homes, incorrect gauge and wiring was used when installing the patio awning motor.
On certain travel and fifth wheel trailers equipped with samsung microwave ovens, models mr1031wb, mr1032bb, mr1033sb, mr1351wb, and mr1352bb, the microwaves were produced with a defective panel. An electrical short can occur between circuit patterns on the...